1. DL manuals
  2. Bunn
  3. Coffee Maker
  4. Axiom-APS SERIES
  5. Installation & Operating Manual

Bunn Axiom-APS SERIES Installation & Operating Manual

Manual is about: axiom series

Summary of Axiom-APS SERIES

  • Page 1

    Installation & operating guide bunn-o-matic corporation of canada 280 industrial parkway south, aurora, ontario, l4g 3t9 phone: (905) 841-2866 fax: (905) 841-2775 to ensure you have the latest revision of the operating manual, or to view the illustrated parts catalog, programming manual, or service ...

  • Page 2

    Page 2 39130.1 051910 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) all equipment other than as specifi ed below: 2 years parts and 1 year labor. 2) electronic circuit and/or control boards: parts and labor for 3 years. 3) c...

  • Page 3

    Page 3 39130.1 112008 user notices carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should be kept in good condition. Replace any unreadable or damaged labels. Introduction this equipment will brew a 1 ⁄ 2 gallon batch of coffee into an awaiting ...

  • Page 4

    Page 4 electrical requirements warning - the brewer must be disconnected from the power source until specifi ed in initial set-up. Refer to data plate on the brewer, and local/national electrical codes to determine circuit requirements. Electrical hook-up (all models) caution – improper electrical i...

  • Page 5

    Page 5 electrical requirements 120v ac single phase models note: this electrical service re- quires 2 current carrying conduc- tors (neutral, and l1) and a separate conductor for earth ground. Requirements for brewers without an attached cord set are as follows: requirements for brewers with an atta...

  • Page 6

    Page 6 39130.1 060810 -1000 213.8 101.0 200 93.3 -500 212.9 100.5 200 93.3 0 212.0 100.0 200 93.3 500 211.1 99.5 200 93.3 1000 210.2 99.0 200 93.3 1500 209.3 98.5 200 93.3 2000 208.4 98.0 200 93.3 2500 207.4 97.4 200 93.3 3000 206.5 96.9 199 92.8 3500 205.6 96.4 198 92.2 4000 204.7 95.9 197 91.7 450...

  • Page 7

    Page 7 39130.1 060810 operating controls (a) enable brew on/off switch pressing the "enable brew on/off" switch (indicator on) supplies power to the brew station warmer and enables the brew circuit. Pressing the switch again (indicator off) stops brewing and de- energizes the brew station warmer. St...

  • Page 8

    Page 8 cleaning 1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on bunn-o-matic equipment. 2. Check and clean the sprayhead. The sprayhead holes must always remain open. Insert the short end of the sprayhead cleaning tool into eac...

  • Page 9: Ready to Brew

    Page 9 adjustments & optional settings ready to brew water temp: 200° 1 3 2 using the menu-driven display on the front of the brewer, the operator has the ability to alter or modify various brewing parameters such as brew lockout, brew volume, brew strength, etc. This allows for the precise brewing ...

  • Page 10

    Page 10 adjustments & optional settings (cont.) set temp: 200° (-) done (+) enter password 0 0 0 exiting brewwizard select recipe ? No yes programming functions - flow chart (cont.) brewwizard enter service #? No yes set password 0 0 0 enter serial # ? No yes drip t i m e 0:30 (-) done (+) set pulse...

  • Page 11

    Page 11 flow chart (cont.) 39130.1 112008 enabl energysavr no done yes calibrate flow ? No yes spray oz/m: 25.0 (-) done (+) enable brewlogic no done yes 0 refill 155 (-) done (+) enabl warmer off no done yes enablefreshtimer no done yes enable clean no done yes (these two screens will change if "br...