Bunn FPGA Installation & Operating Manual

Other manuals for FPGA: Installation & Operating Manual

Summary of FPGA

  • Page 1

    Fpga installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the operating manual, or to view the illustrated parts catalog, programming manual, or service manual...

  • Page 2

    2 36783.1 030912 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) airpots, thermal carafes, decanters, gpr servers, iced tea/coffee dispensers, mcp/mca pod brewers thermal servers and thermofresh servers (mechanical and digital...

  • Page 3

    3 contents user notices .............................................................3 electrical requirements ............................................4 ce requirements ......................................................4 operating controls .......................................................

  • Page 4

    4 electrical requirements the grinder has an attached cordset and requires 2-wire, grounded service rated 230 volts ac, 10 amp single phase, 50 hz for 230v models. P2947 p2947 operating controls off/on/start switch off - (upper position) switching to this position stops all operation of the grinder....

  • Page 5

    5 cleaning exterior surfaces the use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on bunn-o-matic equipment. Care should be taken not to scratch the hopper or windows with any abrasive material. Regular cleaning will keep your grinder loo...

  • Page 6

    6 co arse - fine bunn initial set-up/adjustments the grind can be set from fine to very coarse. The grind may be adjusted for use in most commercial coffee brewers. The following procedures should be used to make adjustments. Note - a change in the burr adjustment will also change the amount dispens...