Bunn Liquid Autofill Kits Installation Instructions Manual

BUNN-O-MATIC CORPORATION

POST OFFICE BOX 3227

SPRINGFIELD, ILLINOIS 62708-3227

PHONE: (217) 529-6601    FAX: (217) 529-6644

37570.0002A   08/11   ©2011  Bunn-O-Matic Corporation 

ULTRA-1 & 2

INSTRUCTIONS FOR INSTALLING 

LIQUID AUTOFILL KITS

INTRODUCTION

These instructions are for installing the Liquid Autofill Kits on Autofill ready ULTRA-1 and ULTRA-2 cold drink dispensers.

INSTRUCTIONS

1.  Unplug machine from power source before removing any panels.

2.  Drain both hoppers and clean the machine if needed before proceeding.

5.  With a standard screwdriver and a 

hammer, punch out the hole needed 

for the level probe. Repeat this step 

for all barrels.

4.  Remove both motor covers and locate 

.50" round knock out in top right area 

of plastic drum mount. Discard screws.

3.  Remove hoppers, drip tray, both side 

panels and front panel.

(Continued)

KIT CONTENTS 

ULT-2  ULT-1

A.  37567.0000 

1* 

- 

Circuit Board, ULTRA 2 Auto-Fill

B.  37962.0001 

1* 

- 

Wire Harness, AF Kit

C.  36329.0000 

2 

2 

Tie, Cable-Nylon  BLK 4.04"

D.  43120.xxxx 

2 

1 

Cover Assy, Motor LAF-BLK

E.  38055.0003 

2* 

1 

Probe Assy, LAF

F.  34362.0003 

4* 

2 

Bushing .156" ID x .490" OD x .12" Flg

G.  00973.0000 

4* 

2 

Nut, KEPS #6-32

H.  43131.0000 

2 

1 

Bracket, Motor Cover Support

I.  43145.0000 

2 

1 

Bracket, Motor Cover Mounting

J.  00970.0000 

8 

4 

Nut, KEPS #8-32

K.  02308.0000 

4 

2 

Screw, Pan Head, Slotted w/serr. #8-32 x .38"

L.  38129.0017 

4 

2 

Hose, Braided .25 ID x 11.0" Lg

M.  21275.0006 

8 

4 

Clamp .406/.504" Dia.

N.  01317.0000 

4 

2 

Screw, Truss Head, Slotted #8-32 x .50"

O.  44194.0000 

- 

1 

Wire Harness (Not Auto-fill Ready)

P.  44195.0000 

- 

1 

Wire Harness (Auto-fill Ready)

* Not included in all kits.