Bunn LPGA Installation & Operating Manual

Summary of LPGA

  • Page 1

    Lpga lpga-2e installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the operating manual, or to view the illustrated parts catalog, programming manual, or servic...

  • Page 2

    2 27091.1 051910 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) all equipment other than as specified below: 2 years parts and 1 year labor. 2) electronic circuit and/or control boards: parts and labor for 3 years. 3) compres...

  • Page 3

    3 contents user notices .............................................................3 electrical requirements ............................................4 ce requirements .......................................................4 operating controls ......................................................

  • Page 4

    4 electrical requirements the grinder has an attached cordset and requires 2-wire, grounded service rated 230 volts ac, 10 amp single phase, 50 hz for 230v models. P1028 p1029 operating controls off/on/start switch (models lpga and lpga-2e) off - (upper position) switching to this position stops all...

  • Page 5

    5 cleaning exterior surfaces the use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on bunn-o-matic equipment. Care should be taken not to scratch the hopper or windows with any abrasive material. Regular cleaning will keep your grinder loo...

  • Page 6

    6 initial set-up/adjustments the grind can be set from fine to very coarse. The grind may be adjusted for use in most commercial coffee brewers. The following procedures should be used to make adjustments. Note - a change in the burr adjustment will also change the amount dispensed. Any adjustment t...