Use and care of your my café ™ tea & coffee pod brewer p2896 model mcpa commercial and household type the bunn logo is a registered trademark of bunn-o-matic corporation. My café is a trademark of bunn-o-matic corporation. 36989.0001b 10/05 ©2005 bunn-o-matic corporation ® model: serial number: reco...
2 hazardous voltage! Can cause fire or electrical shock! Do not disassemble the brewer! There are no user serviceable parts inside! The only user replacement parts are shown on page 19. Repair should be done by authorized service personnel! Table of contents warnings ...................................
3 user notices carefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices on the equipment should be kept in good condition. Replace any unreadable or damaged labels by visiting our web site at www.Bunn.Com. Introduction the bunn ® m...
4 important safeguards follow these basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury: • read all instructions. • do not touch hot surfaces. Use handles or knobs. • to protect against electric shock, do not place cord, plug, o...
5 • use caution when dispensing hot water from the brewer. The water from your bunn ® pod brewer is approximately 93°c (200°f). This is approximately 10°c (50°f) hotter than the hot water from your faucet and must be handled with care. • this brewer is designed to remain plugged in at all times (exc...
6 fig 1. Exploded view fig 2. Control panel water reservoir slide lid pod holder release button pod holder insert pod holder drip tray grate drip tray power switch control panel volume control slide lever heating indicator refill water indicator pod holder indicator coffee brew button* tea brew butt...
7 definitions components • water reservoir - holds reserve water for brewing. The reservoir can be removed and filled separately at a sink or other clean water source or by pouring water through the slide lid. (holds 1.7 l (46 oz.) to the maximum line.) • slide lid - the slide lid allows access to th...
8 • heating indicator - this light indicates that the heater is bringing water up to temperature. A brew cycle cannot be started until the indicator has gone out. (during a brew cycle, this light will come on indicating the tank heater is warming the new water entering the tank.) • pod holder indica...
9 initial brewer set-up 1. Remove the lid and water reservoir. (caution: do not place the brewer in a sink or other water source.) 8. Place a mug or bowl that will hold at least 414 ml (14 fl. Oz.) onto the drip tray grate. 4. Replace the reservoir and lid and close the slide lid. 9. Press and releas...
10 brewing delicious coffee or tea (caution: do not place brewer in sink or other water source.) (note: minimum volume is approx. 118 ml (4 oz.) maximum is approx. 355 ml (12 oz.) settings are in 30 ml (1 oz.) increments.) 5. Place a mug, larger than the volume selected, on the drip tray grate below...
11 hot water the same basic steps used to brew coffee or tea can be used to obtain hot water by leaving the coffee pod or tea bag/pod out of the pod holder. Caution: the water from your bunn ® pod brewer is approximately 93°c (200°f). This is hotter than the hot water from your faucet and must be ha...
12 routine cleaning before beginning any cleaning procedure, unplug the brewer to avoid the accidental start of a brew cycle. Clean the pod holder, drip tray and drip tray grate after each use, using a damp cloth and mild detergent and rinse. With the pod holder and drip tray removed, use a damp clo...
13 8) when the cycle has finished, empty the cup. Repeat step 7 at least two more times to remove the solution from the tank. 9) clean the pod holder with a mild detergent and rinse thoroughly. 10) proceed to the “cleaning the sprayhead/seal” section. Cleaning the sprayhead/seal 1) press the power sw...
14 inspecting the sprayhead seal when disassembling your brewer for cleaning, inspect the sprayhead seal for cracks, tears and holes. Although the seal should last for an extended period of time, damage can occur through handling. Caution: the seal confines the hot liquid to the pod holder. Replace t...
15 troubleshooting situation explanation nothing happens when the coffee button or tea button is pressed. This is the first time you have used your brewer. The initial brewer set-up procedure must be performed first. Please follow the directions on page 9 before attempting to run a brew cycle. Your br...
16 situation explanation the refill water indicator has come on. The pod holder indicator has come on. The water shuts off and comes back on again when brewing. The water reservoir has run low on water. Slide the lid open and pour additional water into the reservoir, or remove the reservoir and fill ...
17 troubleshooting (cont.) situation explanation the pod holder will not come out of the brewer. Water is appearing on the counter around the base of the brewer. Water leaks out around the sprayhead. The pod in the pod holder may have swelled to a point where the holder does not slide out easily. Wa...
18 situation explanation the bunn ® (pod holder release button) indicator is not on all of the time. The heating indicator comes on when the coffee or tea button is pressed. The heating indicator comes on during a brew cycle. When the bunn ® button (also known as the pod holder release button) is li...
19 bunn® replacement parts sliding lid dishwasher safe. Pod holder dishwasher safe. Water reservoir holds 1.7 l (46 oz.) of fresh water for quick brewing. Dishwasher safe. Drip tray and grate dishwasher safe. Catches up to 177 ml (6 oz.) of liquid. Sprayhead precision jetstream ™ sprayhead for full ...
20 limited warranty bunn-o-matic corporation (“bunn” or “we”) warrants to the original user (the “buyer” or “you”) of this pod brewer that the pod brewer is free from defects in material and workmanship existing at the time of manufacture and appearing within two years of the date of original purcha...
