1. DL manuals
  2. Bunn
  3. Coffee Maker
  4. My Cafe MCR
  5. Installation & Operating Manual

Bunn My Cafe MCR Installation & Operating Manual

Manual is about: Bunn My Café MCR Coffee machine - Installation & operating guide

Summary of My Cafe MCR

  • Page 1

    Installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the operating manual, or to view the illustrated parts catalog, programming manual, or service manual, ple...

  • Page 2

    Page 2 49063.2 031314 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) airpots, thermal carafes, decanters, gpr servers, iced tea/coffee dispensers, mcr/mcp/mca single cup brewers, ther- mal servers and thermofresh® servers (me...

  • Page 3

    Page 3 contents warranty .............................................................................................................2 introduction ........................................................................................................3 user notices ...................................

  • Page 4

    Page 4 electrical requirements caution - the brewer must be disconnected from the power source until specifi ed in initial set-up. Refer to data plate on the brewer, and local/national electrical codes to determine circuit requirements. Electrical hook-up caution – improper electrical installation w...

  • Page 5

    Page 5 plumbing requirements these brewers must be connected to a cold water system with operating pressure between 20 and 90 psi (0.138 and 0.620 mpa) from a ½˝ or larger supply line. A shut-off valve should be installed in the line before the brewer. Install a regulator in the line when pressure i...

  • Page 6

    Page 6 water volumes and fl ow settings have been preset at the factory. Refer to "adjustments" section of this manual for the "set brew volumes", should the volume need to be increased or decreased. The brewer is now ready for use in accordance with the instructions for coffee brewing. Initial set-...

  • Page 7

    Page 7 large brew small brew open brew chamber pull bottom or push top of handle to open. Start press the desired brew button. Once the brew cycle is fi nished, remove cup. Brewing 49063.2 032014 insert cup push lid down to close brew chamber. Place cup place empty cup under the brew chamber. Remove...

  • Page 8

    Page 8 cup holder 1. Disconnect brewer from power source and allow to cool. 2. Open the cup holder. 3. Remove cup holder by squeezing it to one side and lifting out. 4. Wash and rinse cup holder. Verify holes are cleared. Caution: cup contains a sharp needle. 5. Wipe off rubber seal under cup holder...

  • Page 9

    Page 9 tank draining tank draining 1. Disconnect the power and water supply to brewer. Allow brewer to cool before proceeding. 2. Remove the top cover. 3. Lift reservoir up and set aside. 49063.2 032014 4. Remove 5 screws securing rear cover. 5. Remove cover. 6. Place brewer next to a sink. 7. Remov...

  • Page 10

    Page 10 programming 49063.2 032014 setting the large and small brew volume: 1. Press and hold the large (to adjust large brew)or small brew switch (to adjust small) for 5 seconds while the brew chamber is open. During that time the red/green leds will fl ash rapidly. After 5 seconds the leds will tu...