1. DL manuals
  2. Bunn
  3. Coffee Maker
  4. SINGLE
  5. Installation & Operating Manual

Bunn SINGLE Installation & Operating Manual

Summary of SINGLE

  • Page 1

    ! Cautio n hot water c a u t i o n : w a r m e r s a n d s u r f a c e s a r e h o t caution discard decanter if: . Cracked . Scratched . Boiled dry . Heated when e mpty . Used on high flame . Or exposed electric elements failure to comply risks injury pn: 658 1985 bunn-o-matic corporation funnel co...

  • Page 2

    392, autopod, axiom, brewlogic, brewmeter, brew better not bitter, brewwise, brewwizard, bunn espress, bunn family gourmet, bunn gourmet, bunn pour-o-matic, bunn, bunn with the stylized red line, bunnlink, bunn-omatic, bunn-o-matic, bunnserve, bunnserve with the stylized wrench design, cool froth, d...

  • Page 3: Chaud

    Page 3 user notices the notices on this brewer should be kept in good condition. Replace unreadable or damaged labels. 12364.7000 warmers and surfaces are hot les rÉchauds et les surfaces sont chaudes caution attention 27038 050412 artwork for p/n: 00658.7000 artwork rev: g updated by: rn date: 02/1...

  • Page 4

    Page 4 electrical hook-up caution – improper electrical installation will damage electronic components. 1. An electrician must provide electrical service as specified. 2. Using a voltmeter, check the voltage and color coding of each conductor at the electrical source. 3. Remove the front panel benea...

  • Page 5

    Page 5 plumbing hook-up note - if a backflow preventer is required by code, a shock arrestor should be installed between backflow preventer and dispenser. Installing the shock arrestor as close to dispenser as possible will provide best results. 1. Attach the flare fitting from the short piece of tu...

  • Page 6

    Page 6 adjusting brew volumes caution - disconnect the power source from the brewer prior to the removal of any panel for the replacement or adjustment of any component. Note: prior to setting or modifying batch sizes, check that the brewer is connected to water supply, the tank is properly filled, ...

  • Page 7

    Page 7 operating controls brew selector switch placing the switch in the 1 ⁄ 2 gal, 1 gal, or 1 1 ⁄ 2 gal position selects the amount of coffee to be brewed in sub- sequent brew cycles. Repositioning this switch after a brew cycle has been initiated does not change the brew batch in progress. On/off...