Bunn ThermoFresh Use & Care Instructions
USE & CARE INSTRUCTIONS for ThermoFresh
®
SERVER
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
Place a cup or container in
center of serving platform
as indicated.
STEP 2
STEP 3
STEP 4
39483.0000A 10/06 ©2006 Bunn-O-Matic Corporation
Open the faucet handle
until the desired quantity is
dispensed.
The Server Cover needs to
be removed to fill the Server
when brewing from a Bunn-
O-Matic
®
Dual TF DBC or
Single TF DBC or ICB coffee
brewer.
DAILY CLEANING
Remove the drip tray and
drip tray cover.
Remove the lid, fill server
with cleaning solution and
thoroughly clean the inside
of server.
Run a complete brew cycle of
just hot water into the server
and let it set for a minute.
Empty the server completely
by opening the faucet.
Turn the server upside
down. Remove three screws
securing the bottom plate
to stand. Using a phillips
screwdriver with at least a
10” shank, remove three
screws attaching the stand
to the server.
When proper precautions
are followed, 1.0 up to 1.5
gallons of coffee may be
brewed directly into the
server and then transported
to a remote serving location.
The server must be placed on
a sturdy counter or shelf.
NOTE: Bunn-O-Matic recommends the 3 step method
for cleaning and sanitizing the server. The 3 step method
consists of hot soapy water using an approved detergent,
a fresh water rinse, and an aqueous sanitizing solution us-
ing an approved non-chlorine sanitizer. Do not submerge
server.
BEVERAGE DISPENSING