Owner’s manual for the ground driven spreader c-dit400gt c-dax systems ltd po box 1010, 145 harts road tiritea, palmerston north ph:06 354 6060 fax:06 355 3199 e-mail: sales@c-dax.Co.Nz www.C-dax.Com.
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 2 safety precautions cdit400gt an important message for owners & operators of c-dax attachments/accessories be warned of the dangers of loading your atv or other vehicle in excess of its carrying capacity. It is important to understand that ...
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 3 safety precautions before attempting to install or operate the equipment, read and understand the manual thoroughly. Failure to comply with this instruction constitutes improper use and will invalidate the warranty. Throughout this manual ...
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 4 c-dax cdit400gt owner’s manual (pt.No.90068 issue 2 dated 02 may 2008) table of contents 2 safety precautions 4 table of contents 5 introduction description specifications order information warranty 6 liability 7 operation 8 calibration ma...
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 5 introduction congratulations. You have just purchased an advanced spreader from c-dax systems. C-dax systems is committed to providing you, the farmer, with quality applicating systems. Description the c-dax c-dit400gt is a ground-driven s...
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 6 the warranty does not extend to cover: consequential damage; repair or replacement of parts due to fair wear and tear; or damage resulting from neglect, misuse, accident or hireage. Specifically the warranty excludes battery damage, damage...
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 7 operation the product to be spread is placed in the hopper. When the spreader is towed forward, the right hand wheel drives through the lever operated mechanical clutch and gearbox to turn the spinner in a clockwise direction. When the con...
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 8 calibration 1. Ensure the control handle is fully back (clutch disengaged, shutter closed). 2. To calibrate your spreader, place a measured amount of product (10 kg) in the hopper. 3. Set the shutter stop lever to the position (1-9) indica...
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 9 operating the spreader when the spreader has been correctly calibrated, the hopper may be filled to the required level and spreading commenced. To reduce agitator damage to product and to ensure that product is not forced past the agitator...
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 10 maintenance the following maintenance actions are mandatory for reliable use of the spreader. Before use check the tyre pressures and charge with air as required. The correct pressure is 15psi (100kpa). Disengage the clutch by ensuring th...
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 11 parts diagram.
X:\technical\contdoc\manuals\current\90068-3-cdit400gt.Doc 12 parts list.
