C-Dax SPREADMASTER Owner's Manual - page 8
8
INSTALLATION
All Models
Unpack the spreader and check the contents. The following parts are included;
Spreader Unit
Console
Owner’s Manual
Shutter Lever Assembly
Shutter Lever Friction Washer
If you have purchased a Quicksmart and/or Quicksmart spreader frame you may also have the
following.
QS Spreader Adaptor Bracket with attachment bolts and nuts (4 sets)
Quick Smart™ATV Bracket with attachment clamps and hardware (4 sets)
Insert the shutter lever into the top bracket on the side of the spreader frame and apply pressure
upward to compress the spring.
Locate the friction washer over the pin at the bottom of the handle and insert the pin into the
bottom bracket on the spreader frame ensuring that the hole in the end of the shutter lever is
located over the pin on the shutter arm on the spreader.
Operate the shutter handle to check that the shutter moves positively and stays in the fully open
and closed positions.
Flatdeck Mounting
Mark and drill four 8mm holes in the vertical surface where the machine is to be attached. Bolt the
machine in place using 8mm bolts of the correct length (client supplied). The minimum
recommended spinner height from the ground is 500mm.
CAUTION
For proper operation of the spreader it is not recommended that it be bolted to a horizontal surface
without additional support for the chassis. If mounting on a horizontal surface use two ‘L’ brackets
(client supplied) to support the rear of the frame.
NOTE
The spreader will need to be in reach so that the operator can work the shutter handle.
Bolt the machine in place using 8mm bolts of the correct length (client supplied).