C-KO C-KO-DVBT-180-Plus User Manual - page 2
1.Front Panel
Ant. In(1)
Rear Display(2)
Front Display(2)
Audio Out R/L(3)
Power(4)
(1) Ant. In: Antenna connection port (NOTE: This unit provides +5V antenna power on these inputs for 5V
active antennas)
(2) VIDEO OUT: Output ports for connection to car monitors. Connect the video output "FRONT and
REAR"with the video inputs of your monitors. The video output "FRONT"can be controlled by the
vehicles handbrake fo avoid danger.
(3) AUDIO OUT R/L: Audio R/L which can be connected to a head unit with stereo amplifier inputs (if
supported).
(4) POWER: Wiring Connection Input harness. The power input is supported either 12V or24V car power
system.
connect the red ACC cable to the
accessories cable of your vehicles
Use the blue +12V output cable to
power your active antennas. If your
active antenna could support the
5V power through RF ,input don’t
need to connect this +12V cable
connect the yellow BAT+ cable
with the (+) pole of battery
connect both black GND cable to
the vehicles chassis ground
AV INPUT
IR
USB
IR. In(5)
AV Input(7)
USB Port(6)
(5) IR. In: Port for connecting the infrared receiver module.(must be connected)
(6) USB Port: For reading USB memory stick.(Max.8GB)
(7) AV Input: Audio/video signal input for external devices such as DVD ,GPS.
2.Remote Help
1.ON /OFF-Turn the TV tuner ON/OFF.
2.Mute-Mute the audio output.
3.Numeric key(0~9) or channel numbers.
4.Vol.+/--adjust the volume.
5.CH.+ / - - Changes to the next / previous channel.
6.Increases/decreases the volume level in no-menu
mode. Moves the cursor in menu mode.
7.Up/Down-Changes the current channel to the
next /previous channel in no-menu mode. Moves the
cursor up/downwards in menu mode.
8.OK-Calls simple channel list in no-menu mode.
Activates the highlighted menu item in menu mode.