Cm2 user manual: magnetometer supplement user manual the cm2 sidescan sonar system magnetometer supplement version 1.4 © c-max ltd 2017 i.
Cm2 user manual: magnetometer supplement (this page intentionally blank) ii.
Cm2 user manual: magnetometer supplement contents 1. Introduction ………… 1 2. Cm2-to-magnetometer interface ………… 2 cm2 system with magnetometer option connection to mm display software magnetometer settings 3. Connection, deployment & recovery ………… 4 connecting the magnetometer launch and recovery ope...
Cm2 user manual: magnetometer supplement bhe cm2's magnetometer interface kit option is intended to work with a marine magnetics explorer or seaspy system. To work with the cm2 towfish the magnetometer must be also accompanied by a sidescan sonar interface kit, manufactured by marine magnetics, that...
Cm2 user manual: magnetometer supplement with the conditional excepftion of the depth message. If the sidescan towfish is fitted with a depth sensor then the depth of the sidescan towfish is copied into the magnetometer depth message. The sonar data and the magnetometer data may be acquired on separ...
Cm2 user manual: magnetometer supplement 3. Connection, deployment and operation connecting the magnetometer before initial use press the nylon sleeve into the 9.8mm (0.385") diameter hole in the universal joint tow connector on the free end of the marine magnetics sidescan interface cable. This sle...
Cm2 user manual: magnetometer supplement to test the system before launch start maxview (or third-party sonar acquisition software) and sealink, then start the cm2 towfish. After a delay of a few seconds power will be automatically applied to the magnetometer and sampling will begin. Launch and reco...
