C.P. Electronics MWS1A-C-PRM-LV Product Manual - Frequency Compatibility
4
C.P. Electronics Ltd
Brent Crescent
London
NW10 7XR
United Kingdom
Tel:
+ 44 (0) 333 900 0671
Fax:
+ 44 (0) 333 900 0674
www.cpelectronics.co.uk
enquiry@cpelectronics.co.uk
Code suffix
Region
Frequency
blank
UK, China, India, Middle East, Malaysia, Hong Kong, Singapore
10.587GHz
-R2
Australia and all of Europe except:
UK, France, Portugal, Germany, Switzerland, Austria, Slovak Republic, Republic of
Ireland
10.525GHz
-R5
Republic of Ireland
10.41GHz
The allowable frequency of operation of this product is different depending on region. Please select the correct order
code using the table below.
Frequency compatibility
Ref: #WD416 Issue 2
FM 45789
EMS 534520
Part numbers
MWS1A-C-PRM
Microwave presence detector (ceiling mounting)
MWS1A-C-PRM-LV
Microwave presence detector (ceiling mounting) Low Voltage
MWS1A-C-PRM-VFC
Microwave presence detector (ceiling mounting) Volt Free Contact
Technical data
Detection pattern
Dimensions
MWS1A-C-PRM
Supply Voltage
230VAC +/- 10%
Frequency
50Hz
Power consumption
On 1.15W
Off - 790mW
Load
10A of lighting and or ventilation
including incandescent, fluorescent,
compact fluorescent, low voltage (switch
primary of transformer).
MWS1A-C-PRM-LV
Supply Voltage
Min 11.5VDC max 36VDC, min 10VAC
max 26.5VAC
Power consumption
On 1.01W
Off - 712mW
Load
Low voltage supply with relay
output rating 16A resistive 10A inductive
MWS1A-C-PRM-VFC
Supply Voltage
230VAC +/- 10%
Frequency
50Hz
Power consumption
On 1.15W
Off - 790mW
Load
Normally closed contact
2 Amp maximum
Minimum load 100mA
Normally open contact
6 Amp fluorescent lighting and resistive
3 Amp compact fluorescent lighting
3 Amp low energy lighting
3 Amp low voltage lighting (switch primary
of transformer)
Fluorescent lighting (max 6 fittings
recommended)
For fluorescent lighting total power factor
correction capacitance must not exceed
40μF.
3 Amp fans and ventilation equipment
Switch SON lighting loads via a contactor
Minimum load 100mA
All models
Weight
0.1kg
Terminal Capacity
2.5mm
2
Time out period
Adjustable 10 seconds to 99 minutes.
Light level
Optional adjustment by using IR
programming handsets.
Fixing method
Surface fixing
35mm deep plastic surface mount moulded
box.
Flush fixing
25mm steel backbox or 25mm deep cavity
backbox.
Temperature
-10ºC to 35ºC
Humidity
5 to 95% non-condensing
Material (casing)
Flame retardant ABS Type Class 2
Compliance
EMC-2004/108/EC
LVD-2006/95/EC
Safety
The microwave radiation emitted by these
units is extremely low power. At a distance
of > 50mm the power density is <6% of the
ANSI IEEE C95.1 –1991 recommended
microwave power density.
At a distance of 5mm from the unit it is
<84% of recommended power density.
Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior notice.