C.T.M. HS-290 Instruction Booklet - page 9
Instruction Booklet
HS-290
Figure 4
Figure 4
Function Of Parts
:
TOP CONTROL PANEL
•Speed Dial Knob
The Rabbit means fast and turtle means slow. By turning this knob, you can control total
speed transferred to thumb controls.
•HeadLight Switch
To switch headlight on & off by pressing the headlight switch.
•Self Diagnostic Warning Light
Flashing indicates there is a problem within scooter. See page 16 for more information.
•Battery Gauge
There are five green LED lights. When all LED are on, batteries are fully charged. When
only two lights are on, batteries need to be recharged.
ADJACENT TO TOP CONTROL PANEL
•Thumb Lever
Pushing right thumb lever forward moves scooter forward. Pushing left thumb lever
forward will move scooter backward. (This configuration can be reversed if required
by local authorized dealer.) While in use, this lever is also your accelerator. The further
you depress the thumb lever, the faster you will go. (NOTE: subject to the position of
the rabbit/turtle control).
AT BASE OF TILLER
•Tiller Angle Adjustment
Push downward on the lever to loosen, and move tiller to adjust. The lever will lock tiller
automatically in 3 different angles.
BELOW SEAT
•Seat Lock Knob
Turn seat lock knob counterclockwise to loose. Turn it clockwise to lock seat in position.
•Seat Rotating Lever
By pulling lever upwards to rotate to different
direction.
•Armrest Width Adjustment Thumbscrews
Loosen the two thumbscrews to adjust arm width;
tighten again to lock into desired position.
7
Left and
right
adjustment
Counterclockwise
to loose