C.T.M. HS-5600 User Manual - page 11
User's Manual
HS-5600
9
CHARGING THE BATTERIES
Your C.T.M. power chair is equipped with two sealed, service free 12V rechargeable
batteries and one 24V. 5A charger. Batteries must be charged before using the chair
for the first time and should be recharged after each day's use. Be sure the power
switch is in the OFF position.
1.Ensure the voltage switch on the battery charger. Use 115V for 110v circuits and 230v
for 220v circuits.
2.Ensure the main switch on the battery charger is OFF (position O).
3.Insert battery charger output terminal (E) into the chair charging port.
4.Plug the other end of the battery charger cable (F) into a standard electrical outlet.
5.Turn main switch on the battery charger to ON (position I).
6.The battery charger lights will normally be red and yellow at this point. Check whether
you can hear the fan running. If the lights are not on or the fan is not running, turn OFF.
Disconnect the battery charger and check the fuse for burnout. Replace fuse if necessary.
Reconnect and try again. If it still does not work, contact your authorized dealer.
7.Allow to charge until the right battery charger light turns green.
8.After the light turns green, turn OFF battery charger, then unplug the battery charger
from the chair.
9.If at any time the right battery charger light flashes green over 40 minutes, this indicates
abnormal charging occurred. You should check that:
•charger plugs are correctly positioned
•fuse is not burned out
•the scooter is turned off
•if none of these is a problem, contact your authorized dealer.
Figure 17
Figure 17
Do not place battery charger on batteries or close to other objects, so
that heat can dissipate.
The time needed to recharge will vary depending on the depletion of the
batteries. Charging for longer than necessary will not harm the batteries.
They can not be overcharged.
(E)
(F)