Edition 12/03 external unwinder eu4 for thermal transfer printer a3/a4/m4 art.-no. 5946091 external unwinder eu6 for thermal transfer printer a6 art.-no. 5946421 external unwinder eu8 for thermal transfer printer a8 art.-no. 5945806 operator’s manual.
2 technical specifications label width eu4: up to 4.7 in ( 120 mm) eu6: up to 7 in ( 180 mm) eu8: up to 9.1 in ( 235 mm) unwind diameter max. 11.7 in ( 300 mm) core diameter 1.56 in ( 40 mm) on cardboard core 3 in ( 76 mm) on cardboard core with adapter label rewinding labels inside or outside dimen...
3 delivery contents notice ! Retain packing material for later use ! 1 - unwinder 2 - winding axle 3 - 2 flanges 4 - 2 winding adapters 5 - 8 screws 6 - operator's manual 1 4 5 2 3 6.
4 fig. 1 placing the unwinder for outside wound labels 7 7 placing the unwinder when you switch between outside and inside wound materials you have to turn the unwinder 180 degrees. Compare for this in the two following figures the position of the swing arm (7). Fig. 2 placing the unwinder for insid...
5 media loading preparing the winding axle and the flanges there is a spring (8) mounted on the winding axle (2) to guarantee a properly stability of the unwinding material when using rolls with a 1.56 in ( 40 mm) cardboard core. When unwinding from rolls with a 3 in ( 76 mm) cardboard core this spr...
6 notice ! Before mounting the winding axle read this chapter and "insertion of the prepared winding axle" and attend on the running of the media in dependence to inside and outside wound label rolls. Notice ! For rolls with 1.56 in ( 40 mm) cardboard core you have to dismount the winding adapters f...
7 - slide the flange (3a) on the winding axle (2) so that the attachment of the flange points to the outside. - align the flange (3a) so that the screw (10) grasps into the groove (11) of the winding axle (2). Tighten the screw (10) in the flange. - slide the material roll (12) onto the axle until i...
8 - hang up the axle with material in the unwinder. When hanging up, the flange with the knurled screw has to be in front. - feed the label strip (14) over the swing arm (7) and the rewind axle (15) to the printer. - insert the material according to the instructions of the printers operator`s manual...
9 adjusting the unwinder to avoid crinkling in the material running the unwinder has to be aligned exactly to the printer. For a trouble-free adjustment of the unwinder to a printer of the a- or m-series an adapter kit ( part no. 5948170) is offered. The printer is correct aligned, when the running ...
Copyright by cab / 9008309 / xxx / x angaben zu lieferumfang, aussehen, leistung, maßen und gewicht entsprechen unseren kenntnissen zum zeitpunkt der drucklegung. Änderungen sind vorbehalten. All specifications about delivery, design, performance and weight are given to the best of our current knowl...
