1. DL manuals
  2. CAB
  3. Label Maker
  4. E4/200
  5. Quick Start Instruction Manual

CAB E4/200 Quick Start Instruction Manual

Summary of E4/200

  • Page 1

    E4 printer quick-start instruction manual step # 1. Loading the media (label tape) into the printer. 1. Media roll guides 3. Media spindle 5. Media holder 2. Media core adapters 4. Media roll 6. Media guides 1. Open the top cover. 2. Place the media roll (4) onto the media spindle (3). ( for media r...

  • Page 2

    4. Place the media spindle with the media roll into the media holder slots (5) in the printer. ( the media must unroll with the adhesive side down) 5. Position the media in the center of the media spindle and slide the media roll guides (1) up against the media roll. 6. Release the printhead module ...

  • Page 3

    Step # 2. Positioning the media sensor 1. Media sensor 3. Media 2. Media sensor cover 4. Gaps between labels 1. Position the media sensor (1) by sliding it left or right until the sensor is in alignment with the gaps in the label tape (4). ( the sensor can be positioned to detect the gaps along the ...

  • Page 4

    Step # 3. Loading the transfer (ink) ribbon 1. Ink ribbon spindle 4. Ribbon supply holder 2. Ink ribbon 5. Ribbon rewind holder 3. Empty ink ribbon core 1. Slide the ink ribbon (2) onto one of the ink ribbon spindles (1) exactly as shown in fig (a). ( the "flat end" of the ink ribbon spindle must be...

  • Page 5

    4. Install the ink ribbon spindle with the empty ink ribbon core into the ribbon rewind holder (5) in the printer, exactly as shown in fig (d). 5. Pull the ink ribbon around the printhead module and attach the end of the ink ribbon onto the empty ink ribbon core as shown in fig (d). 6. Turn the ribb...

  • Page 6

    Step # 4. Calibrating the media sensor calibrating the printer is required when installing label tape for the first time or when changing label tape to a different size. Calibration is recommended when changing label tape and/or ink ribbons to maintain correct label alignment. To calibrate the print...