Cable Electronics CE Labs SW404HD Instruction Manual

Other manuals for CE Labs SW404HD: Instruction Manual

Manual is about: Cable Electronics High Definition Matrix Switch Instruction Manual

Page of 16

Download

Print this page

Bookmark us

INSTRUCTION MANUAL

High Definition Matrix Switch

SW404HD | SW808HD

CE labs can support many areas of your audio and video

distribution needs.

We manufacture:

• Digital Signage software and Media Players

• HD Matrix Switchers

• RF amplifiers

• HDMI and Component HD distribution amplifiers

• CAT 5 Signal Extenders

• VGA Extenders and Splitters

• and cables of all types.

See our full product line at

www.celabs.net

WARRANTY

Cable Electronics, Inc. warrants this product to be free from defects in

material and workmanship, under normal use and service, for a period of

one year from the purchase by the original purchaser. If this product is

defective or malfunctions, Cable Electronics will replace or repair this unit

(at their option) within a reasonable time. No expressed or implied warranty

is made for any defects caused by immersion or exposure to liquids, abuse,

neglect, improper operation of unit, excess wear and tear and defects

resulting from unauthorized disassembly and or modification.

Document:

SW404HD_SW808HD_manual.pdf

3209 Wood Drive

Garland, TX 75041

Phone: (469) 429-9200

Toll free: (800) 767-6189

Fax: (469) 429-9205

www.celabs.net

1 2 3 4 5 6 7 Next › »

Summary of CE Labs SW404HD

Page 2
1. Read manual - carefully read the manual. 2. Installation environment - the system should be installed indoors only. Install either in a sturdy rack or on a table in a well-ventilated place. 3. Lightning - unplug the power cord during lightning or after prolonged period of non-use to avoid damage ...
Page 3
Table of contents matrix system overview: matrix system matrix system models matrix system packing matrix host installation matrix system front/rear panels: model sw404hd front/rear panels model sw808 hd front/rear panels matrix and peripherals connection input/output jacks connecting audio/video ca...
Page 4
Matrix system the matrix switch is a high performance system used to switch audio/video frequencies. It will cross switch multiple input/output audio/video signals through independent y/pb/pr component and audio input/output terminals. Each y/pb/pr component signal and audio signal is transmitted se...
Page 5
Model sw404hd front/rear panels command packet command packets are sent to the matrix switch from a computer and are 4 or more bytes long depending upon the instruction code. Command type a or command type b response packet response or acknowledgement (ack) packets are returned from the matrix switc...
Page 6
Matrix switch communication protocol the rs-232/rs-485 communications are half-duplex with variable byte count packets. For rs-232, the matrix switch operates as a dce device and therefore can be connected using a straight cable to a dte device such as a computer. The rs-232 connector is a db-9 fema...
Page 7
Input/output jacks dependent on the matrix model installed, the video signal input/output jacks are arranged in either 4 or 8 columns of rca female connectors. The connector rows from top to bottom are: y video (green), pb/cb video (blue), pr/cr video (red), right audio signal (red), and left audio ...
Page 8
Connection method the audio inputs and outputs can be separately connected to audio signal connectors of video recorders and multiplexers. Use the rca cables for connecting av equipment to the matrix. Connect the video and audio connectors of the signal source equipment output terminals to the same ...
Page 9
Exit function description used to exit the operating software. Other usages displays the presently saved switching status as shown below: this table shows the video/audio input ports corresponding to the output ports. When a port is closed, zero will be shown in that box. Communication protocol and ...
Page 10
Rs-485 communication port connection methods the rs-485 port will control more than one product. The rs-485 port is shown below. A. Dip switch 8:(rs-232/rs-485 on/off) • on:rs-232 enables single system or rs-485 serial master • off:rs-485 enables rs-485 serial slave b. B. Dip switches 6 and 7 (rs-48...
Page 11
Example: close the output ports 03, 05, and 06. Step 1: first press down the output number keys 03, 05 and 06 to the right step 2: press the disconnect key step 3: press the previously pressed output number keys 03, 05 and 06 (or press the deselect all output key) to complete the operation. The fina...
Page 12
Disconnect function keys close all the unused output ports. A specific example of operation is described below: the default input and output relations are shown below: matrix system and control system connection - rs-232 pc rs-232, multi-matrix (up to 32) connections are as shown below. Notes: 1. Fo...
Page 13
Matrix system and control system connection - rs-485 pc rs-485, multi-matrix (up to 32) connections are as shown below. Notes: 1. Rs-485 baud rate: 9600bps, 8-bit data transmission address, no, odd, or even parity 1-bit stop address: (9600 – 8 - n - 1). 2. Connect pc rs-485 port to the matrix rs-485...
Page 14
Matrix control panel operations input/output switching key operation mode the front panel keys of the matrix system are used for fast audio/video switching (for ils refer to the front panel key functions). Operation operation consists of three basic steps: • choose the switching method • select the ...
Page 15
Matrix application software software introduction the (av matrix) matrix control software is used to remotely configure one or more of the sw404hd or sw808hd matrix switches. Software description the av matrix testing software application tool is used for matrix testing and application. The followin...
Page 16
Operation examples example 1: synchronously connect the number 1 audio/video input signals to the number 3 and 4 output channels (audio and video enabled). Example 2: connect number4 video input signals from channel to number 1, 3, 5 and 6 output channels (audio disabled and video enabled). Operatio...