Cables To Go 39961 User Manual - Installation
of
6
Installation
1. Turn off the PC and monitor(s).
2. Connect the HD-15 female input connector on the VGA over UTP Extender Base Unit (sold
separately) with the HD-15 male to male cable to the PC.
3. At each remote location, connect the HD-15 female output connector on the VGA over UTP
Extender Remote Unit with HD-15 male cable from your monitor(s).
4. If you have local monitor, connect the HD-15 male cable from that monitor to the female output
connector on the Base Unit.
5. Connect the Base and Remote units together with a CAT5E cable.
6. Connect a power adapter to both the Base and Remote unit.
7. Turn on the monitor(s) and PC.
Application Diagram
REAR PORTS
1. VGA Out (HD-15 Female Connector)
FRONT PORTS
1. Power jack
2. Power LED
3.
CAT5 (RJ-45 Connector)