Cabletron Systems CSX400 Setup Manual
— 1 —
— 4 —
Printed On
Recycled Paper
WPIM SETUP GUIDE
This Setup Guide provides the information
necessary to prepare and install a Cabletron
Systems WPIM. This Setup Guide should be used
only after you have read the detailed preparation
and installation instructions contained in the
CSX200
,
CSX400 and CSX400-DC
, and
HSIM-W6
User’s Guides
.
If you need additional support related to this device,
refer to the
CSX200
,
CSX400 and CSX400-DC
, and
HSIM-W6 User’s Guides
. Locate these guides by
clicking on the Cabletron Systems QuickSET
program group icon on your desktop after installing
the QuickSET CD.
NOTE:
Some WPIMs for the CSX200, CSX400 and
CSX400-DC, and HSIM-W6 require version 1.02 or
greater of QuickSET to participate and function
correctly in your network. Contact Cabletron
Systems for technical support to obtain the latest
version of QuickSET. Refer to the
Getting
Help
section of this Setup Guide.
UNPACKING THE WPIM
1. Carefully remove the WPIM from the container.
2. Visually inspect the WPIM. If there are any signs
of damage, contact Cabletron Systems
immediately. Refer to the
Getting Help
section of
this Setup Guide.
Only qualified personnel should install the
WPIM. This Setup Guide is intended for the
experienced network equipment installer.
Both the WPIM and the unit in which the
WPIM is installed are static sensitive
devices. Use a grounding strap and follow all
static safe precautions during installation.
Failure to do so could result in damage to the
WPIM and the unit receiving it.
WPIM LEDs
WPIM LED indications may vary depending on the
module or chassis in which a WPIM is installed into.
For more information on LED indications, refer to the
Troubleshooting
chapter of the
CSX200
,
CSX400
and CSX400-DC
, and
HSIM-W6 User’s Guides
.
GETTING HELP
If you need additional support related to this device,
or if you have any questions, comments, or
suggestions concerning this Quick Setup Guide,
contact the Cabletron Systems Global Call Center:
Phone:
(603) 332-9400
Internet mail:
support@ctron.com
BBS:
(603) 335-3358
www:
http://www.cabletron.com/
(For additional information about
Cabletron Systems products)
NOTICES
Cabletron Systems reserves the right to make changes in
specifications and other information contained in this document
without prior notice. The reader should in all cases consult
Cabletron Systems to determine whether any such changes have
been made. The hardware, firmware, or software described in this
manual is subject to change without notice.
IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR
ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL
DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO
LOST PROFITS) ARISING OUT OF OR RELATED TO THIS
MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF
CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR
SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH
DAMAGES.
Order Number: 9032302-01, August 1997
Copyright 1997 by Cabletron Systems, Inc.,
P.O. Box 5005, Rochester, NH 03866-5005
Printed in the United States of America