Mmac-plus ™ module local management 9e312-12 module specific appendix 9031505 draft.
1 appendix 9e312-12 module specific information introduction this appendix contains local management information that is specific to the 9e312-12 ethernet switch module. The 9e312-12 ethernet switch module is a 13-port switching module with: • 12 front panel ethernet ports • 1 internal network bus (...
9e312-12 module specific information 2 module interface codes the 9e312-12 ethernet switch module has 15 interfaces. The table below lists the identifying number, name, and description of each interface. Use the numbers listed in table 1 to configure the module’s default interface (see the general c...
3 appendix full duplex configuration screen the 9e312-12 full duplex configuration screen displays the port number, operation mode, link status, and port status of the module’s 12 ports. Figure 1. 9e312-12 full duplex configuration screen mmac-plus local management full duplex configuration module n...
9e312-12 module specific information 4 full duplex configuration screen fields port # (read-only) - displays the numbers for each of the ethernet ports. Operation mode (modifiable) - this field lets you determine whether the specified port will transmit and receive data separately or simultaneously....
5 appendix port status (read-only) - indicates whether the port has been turned on or off administratively. You will see one of the following values: • enabled - the port is turned on administratively. • disabled - the port is turned off administratively. Enable or disable ports from the bridge conf...
9e312-12 module specific information 6 port statistics screen the 9e312-12 port statistics screen displays information and statistics about the module’s 12 ethernet ports. Figure 2. 9e312-12 port statistics screen mmac-plus local management port statistics module name: 9e312-12 firmware revision: 01...
7 appendix port statistics screen fields port # (read-only) - indicates the current port for which statistics are displayed. Octets (read-only) - displays the number of bytes transmitted and received. Packets (read-only) - displays the number of frames transmitted and received. Total errors (read-on...
9e312-12 module specific information 8 port status (read-only) - indicates the status of the selected port. Possible values are enabled and disabled. Application (read-only) - displays bridging, indicating that the port is operating as a bridge with a high-speed backbone connection. Operation mode (...
