Cabletron Systems SmartSTACK 100 ELS100-24TX User Manual Addendum - page 12
8 SmartSTACK ELS100-24 Firmware Revision 2.01
9033194
6.
In this example, a range of ports is entered to form a trunk group.
Enter
1-4
and press [Enter]. Figure A-5 shows the update to the
screen.
Figure A-5. Adding a Range of Ports to a Trunk
7.
To add a trunk name, enter
c
. The following message appears:
Enter Trunk Name:
8.
Enter a trunk name. In this example, enter
Backbone
and press
[Enter]. This new name appears in the Name field.
9.
Enter
x
to return to the previous menu. Figure A-6 shows the ports
that have been configured in trunk group 1.
Figure A-6. Ports Configured in a Trunk Group
10.
To view Trunking Statistics, return to the Main Menu, and select
Switch Statistics, then Trunking Statistics. When displaying statistics
for a trunk group, the statistics are the sum of the statistics for all
physical ports in the trunk group.
TRUNK 1 CONFIGURATION
Access Control: READ/WRITE
Name
Trunk Status
CONNECTED
Trunking Protocol No
PORT ENABLED
LINK STATUS
---------------------------------------------------------------------------------------------
1
Yes
CONNECTED
2
Yes
CONNECTED
3
Yes
CONNECTED
4
Yes
CONNECTED
a. Add Port(s)
b. Remove Port(s) c. Trunk Name
d. Protocol Enable
x. Previous Menu
Enter Selection:
TRUNKING CONFIGURATION
Access Control: READ/WRITE
Trunking Protocol No
ID
NAME
PORTS IN TRUNK
---------------------------------------------------------------------------------------------
1
Backbone
1-4
c. Configure d. Delete e. Enable x. Previous Menu
Enter Selection: