Cabletron Systems TRFOT-2 User Manual - page 16
INSTALLING THE TRFOT-2
Page 3-6
Figure 3-4. Attaching the Power Supply
3.6
MOUNTING THE TRFOT-2
To wall-mount the TRFOT-2, use the Cable Mounts, Tie Wraps, and
Velcro Strips included with the unit. Refer to Figure 3-5 and perform
the following steps:
1.
Remove the tape from the adhesive backing on the Velcro strips.
2.
Place one Velcro half on the TRFOT-2 and the other half on the
mounting surface.
3.
Press firmly on each Velcro strip, then press the TRFOT-2 onto the
mounting surface.
4.
Secure the TRFOT-2’s cables to the wall using the adhesive backed
cable mounts and tie wraps.
Figure 3-5. Mounting the TRFOT-2
Cable Mounts and Tie Wraps
TX
RX
802.5 TOKEN RING COPPER
TO
FIBER OPTIC
TRANSCEIVER
WITH
LANVIEW
®
P
W
R
C
U
F
O
LNK
POWER REQUIRED: 9-12V ----,500mA MAX
DATA CAPABILITY: 4/16Mb/s AUTO SENSING
UL
SA
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
SN
A B C D
POWER
INPUT
TRFOT-2