CAC / BDP 38GVM Owner's Manual

Manual is about: Multi---Split High---Wall Ductless Split System 38GVM Sizes 018k, 24K, 30K, 36K, and 42K 40GVM Sizes 9k, 12k, and18k

Summary of 38GVM

  • Page 1

    40gvm / 38gvm owner’s manual multi---split high---wall ductless split system 38gvm sizes 018k, 24k, 30k, 36k, and 42k 40gvm sizes 9k, 12k, and18k table of contents page safety precautions 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 2: Warning

    2 safety precautions personal injury, death, or property damage hazard failure to follow this warning could result in personal injury, death, or property damage. Read and follow all instructions and warnings, including labels shipped with or attached to unit before operating your new air conditioner...

  • Page 3

    3 indoor unit part identification hea t cool tempera t ure run dehumidify signal receiving window display closeup air intake air outlet drain hose remote control holder 7 1 2 3 5 6 8 9 10 4 7 front panel frame display panel (shown for 40gxm units)* front panel air filter horizontal airflow louver ma...

  • Page 4

    4 remote control part identification 1. Remote control display 2. On/off button 3. Mode button 4. Setpoint clock, timer up (+) and down (---) buttons 5. Fan speed 6. Horizontal louver swing button 7. Clock button 8. Timer on button 9. Dry coil button 10. Temperature button 11. Timer off button 12. T...

  • Page 5

    5 display panels note: the temperature readout is either setpoint or room temperature and will be replaced by an error code if there is a malfunction. A12434 unit display note: the display panel on the indoor unit can be turned on or off using the remote control. Press the light button to turn the d...

  • Page 6: Caution

    6 remote control equipment damage hazard failure to follow this caution may result in equipment damage. Handle the control with care and avoid getting the control wet. Caution ! Note: the remote control is factory set to display temperatures in _f. If _c is desired, turn the remote off and then pres...

  • Page 7

    7 manual switch auto/stop a12433 the following occurs when the auto button is pushed: s no temperature will be displayed on display panel. S unit will run in fan only mode if return air temperat- ure is between 68_f (20_c) and 77_f (25_c). S unit will run in heating if return air temperature is less...

  • Page 8

    8 the fan speed is selected by pressing the fan button. This button is used to set the fan speed in the following sequence: fan speeds: low medium high note: when the unit is on, the fan will run continuously in cooling or heating. When in heating, there might be situations where the fan will slow d...

  • Page 9

    9 sleep mode this mode is used to conserve energy and can be used when the unit is in the cool, heat or dry mode only. For cooling mode: s push the sleep button. The sleep display will appear on the remote control. Oper ºf ºc hour on/off : a09644 s after 1 hour the set point will be raised by 1.8_f ...

  • Page 10

    10 light function this function will allow the user to turn on or off the display on the front panel. Press the light icon to turn the indoor unit front panel on or off. The remote control will display the light icon as shown below. Light icon a12435 time delay if the on/off button is pressed too so...

  • Page 11: Warning

    11 cleaning, maintenance and troubleshooting ! Warning electrical shock hazard failure to follow this caution may result in personal injury or death. Always turn off power to the system before performing any cleaning or maintenance to the system. Turn off the outdoor disconnect switch located near o...

  • Page 12

    12 table 1—periodic maintenance indoor unit every month every 6 months every year clean air filter* change remote control batteries s s s outdoor unit every month every 6 months every year clean outdoor coil from outside clean outdoor coil from inside† blow air over electric parts† check electric co...