CADDX ranger 8600 User Manual - page 7
8
SERVICE CONDITION
The “Ready” LED will flash in the event of a system fault. Press [
U
]-[2]-[2] to identify the
source of the fault. One or more zone lights will illuminate indicating what service(s) is
required. Call your service provider immediately for these problems. Below is a listing of what
each light means in a service condition.
Light
Service Condition
1
Telephone Line Fault
2
Bell Fault
3
Fuse
4
Fail to Communicate
5
Bell Overcurrent
Press any key to exit this mode.
TESTING YOUR SECURITY SYSTEM
There are several tests you should perform on a periodic basis (at least once a week) to insure
that your Security System is functioning properly.
Enable the "CHIME" Feature and open all protected windows and doors. The Keypad
Control should sound (beep) for each device and the appropriate yellow zone light should
blink.
Walk into all areas protected by motion detection devices while someone observes the
Keypad Control. The appropriate yellow zone light should blink for each sensor tested.
If your system has a "FIRE" Zone, the Smoke or Heat detectors should be tested at least
monthly. If your Security System is monitored by a Central Monitoring Station, always call
before to let them know that you are about to conduct a test of the fire detection system.
Always call after the test to ask for results and to put your fire detection system back into
service.
If the Siren/Bell test option has been selected by your installing company, you may activate
the siren/bell by pressing the one [1] and the seven [7] keys at the same time for one
second. To silence the siren/bell, enter your 4 digit Master or Auxiliary Code.
If any of the above tests are not successful or the results unclear, contact your service
company at the phone number listed on page 1 of this booklet.
www.ealarm.com.my