Security control system user’s manual.
Armed light indicates system is ready light indicates all zones armed. Flashing armed light power light indicates ac zone light indicates status of zones. Are secure or bypassed, and indicates previous alarm. Power is present to your on means zone(s) bypassed, system is ready to arm. System. Flashin...
Security system notes installing/service company for service call special codes master code duress code “quick arm” digit “chime” digit “entry-guard” digit auxiliary arm/disarm codes 02 03 04 - - 05 - - 06 07 08 09 10 11 12 15 19 20 21 22 23 24 25 26 27 28 29 30 entry/exit delay times exit delay tim...
This manual is furnished to help you understand your security system and become proficient in its operation. All users of your security system should read and follow the instructions and precautions in this booklet. Failure to do so could result in the security system not working properly. This book...
How to arm your security system to turn the security system on, close all of the protected doors and windows. The green “ready” light on the keypad control will illuminate when all of the protected areas and sensors are secure. If any of the zones are bypassed, a sensor in that zone can be violated ...
Keypad control tones (beeps) a sounder is built into the keypad control and may sound for one of the following reasons: beeps for all keypresses. Beeps continuously during the entry delay time. Pulses when a day zone is violated and the system is disarmed, a fire zone has a trouble condition, or whe...
Q instant/delay option if checked, your installing company has selected the “instant” option. With this feature enabled, if you do not wish to have a delay on your entry/exit doors, this can be accomplished by pressing the key on your keypad while the system is “armed”. At this time, the “instant” l...
Fire zone if checked, your system has designated “fire” zones. When this option is selected, and approved heat or smoke detectors are attached to the selected zones, a steady audible siren can be initiated from the security system. You should familiarize yourself and your family or staff with this s...
Changing the master code the master code is user code and must be programmed by referring to its code. For example, if the master code is and you want to change it to the sequence would be as follows. Press (this enters programming for user then press (old master code) followed by the new master cod...
Emergency evacuation plans an emergency evacuation plan should be established for an actual fire alarm condition. For example, the following steps are recommended by the national fire protection association and can be used as a guide in establishing an evacuation plan for your building. Draw up a fl...
