Cadet BASEBOARD Owner's Manual

Other manuals for BASEBOARD: Owner's Manual

Summary of BASEBOARD

  • Page 1

    Cadetheat.Com tel: 855.Cadet.Us po box 1675 vancouver, wa 98668-1675 electric baseboard heater owner’s guide http://cadetheat.Com/install/bb for how-to videos or more information, please visit : b aseboard sensible, quiet heat starts here espaÑol ver la guía del propietario en cadetheat.Com/español/...

  • Page 2

    Save these instructions important instructions 2 know your voltage! Tools required or you may need 1. Read all instructions before using this heater. 2. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flam - mable vapors or liquids are used or s...

  • Page 3

    Installation instructions 3 step 1 locate or route electrical supply wires; mount heater to wall 1. All electrical work and materials must comply with the national electric code (nec), the occu- pational safety and health act (osha), and all state and local codes. 2. Use copper conductors only. 3. D...

  • Page 4

    Installation instructions 4 figure 8a figure 7a • know your voltage and check your breaker! • all baseboards require three supply wires. For 120 volt baseboard wiring you will have 1 hot, 1 neutral and 1 ground. For 240 volt baseboard wiring you will have 2 hots and 1 ground; no neutral needed. Step...

  • Page 5

    Installation instructions 5 6. Screw wiring compartment cover back on. 7. Turn power back on at the main disconnect panel. 8. Proceed to operating instructions. How to operate your heater the room temperature is controlled by a line voltage thermostat located either on the wall, or on the heater. On...

  • Page 6

    Maintaining your heater rev 12/15 #720001 6 symptom problem solution reduce-reuse-recycle this product is made primarily of recyclable materials. You can reduce your carbon footprint by recycling this product at the end of its useful life. Contact your local recycling support center for further recy...