Cadet Hot One Owner's Manual

Summary of Hot One

  • Page 1

    Owner’s guide the hot one models: rcp402s rcp502s • commercial grade high temperature manual reset with 25 amp rating at 240 volt • fan delay eliminates cold draft on startup and disperses residual heat on shutdown • fan only control for cool air circulation • 6 foot cord with polarized 240 volt plu...

  • Page 2

    2 placement: the hot one may sit on floor or be mounted to a wall using universal bracket. If mounted on the wall, the top of unit should be 12 inches below ceiling. Thoroughly inspect your heater for any shipping or handling damage and remove any paper or packaging material found around the heater....

  • Page 3

    3 important! Always connect heater to properly grounded outlets. Important! This is a 240 volt heater and requires a 240 volt wired receptacle. Do not alter cord. Important! The fan will delay approximately 20 seconds on startup, and will continue for approximately 70 seconds after elements shut off...

  • Page 4

    4 warranty troubleshooting chart warranty information maintenance: for safer operation and to prolong the life of the heater, it is necessary to follow the maintenance instructions included with each heater. Failure to properly maintain the heater will result in the warranty being voided. All warran...

  • Page 5: The Hot One

    1 guÍa para el propietario the hot one modelos rcp402s rcp502s • reglaje manual de alta temperatura de calidad comercial con califi cación de 25 amperios a 240 voltios. • la demora (retraso) del ventilador elimina las corrientes de aire frías al arrancar y dispersa el calor residual al apagarse. • c...

  • Page 6

    2 ubicaciÓn: el caliente debe ser ubicado sobre el piso o debe colocarse en la pared utilizando una abrazadera universal. Si se coloca en la pared, la parte superior de la unidad debe estar a 12 pulgadas deba- jo del cielo raso. Inspeccionar cuidadosamente su calentador para verificar que el mismo n...

  • Page 7

    3 advertencia: este calentador es un electrodoméstico importante que requiere las conexiones eléctric- as adecuadas para ser utilizado con seguridad. Enchufar el calentador directamente en un toma de corriente de la pared o piso. Enchufar el cable eléctrico en un toma de corriente de 240 voltios. El...

  • Page 8

    4 garantía guÍa de resoluciÓn de problemas información sobre la garantía mantenimiento: para un funcionamiento más seguro y para prolongar la vida del calentador, resulta necesario respetar las siguientes instrucciones de mantenimiento que se incluyen con cada uno de los calentadores. No realizar el...