Cadet RBF Series Owner's Manual
The RBF Series
MODELS:
RBF101 (Supersedes Models RB101 & RB121)
Features & Benefits
■
Retrofits into model RBC wall can or use
with wall can model RBFC
■
Primary and Secondary Thermal Safeguards
•
Robust, heavy duty high temperature
manual power reset
•
Over-temperature one-time thermal fuse
■
Nichrome element wrapped around mica
insulators for durability
■
Powder coat paint process eliminates sharp
cutting edges
■
Stainless steel grill and frame
■
Convenient ON-OFF rocker switch control
■
Two year extended warranty
■
Factory tested and UL listed
WARNING
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and lock
or tag the panel board door to prevent someone
from turning on power while you are working on
the heater. Failure to do so could result in
serious electrical shock, burns, or possible death.
SAVE THESE INSTRUCTIONS
1. Read all instructions before using this heater.
2. Read all information labels.
Verify that the electrical supply
wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
4. Connect the grounding screw provided in the wall can to the
supply ground wire.
5. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
7
.
WARNING!
Overheating or fire may occur. DO NOT
install the heater in
a floor, ceiling, or behind doors.
8
.
WARNING!
Fire or explosion may occur. DO NOT
install heater in any
area where combustible vapors, gases, liquids, or excessive
lint or dust are present.
9
.
WARNING!
Burn Hazard.
This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. Use extreme caution
when any heater is used by or near children or invalids.
10
.
WARNING!
Risk of Electrical Shock.
Connect grounding lead to grounding
screw provided. Keep all foreign objects out of heater.
11
.
WARNING!
Risk of Fire. Do not block heater.
Heater must be kept clear of
all obstructions: a minimum of 3 feet in front, 6 inches above
and on both sides. Heater must be kept clean of lint, dirt and
debris. (See Maintenance Instructions).
12
.
Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electrical shock, or injury to persons.
IMPORTANT INSTRUCTIONS
OWNER’S GUIDE
www.cadetco.com Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675
TOOLS REQUIRED:
•
Phillips Screwdriver
•
Straight Screwdriver
•
Wire Strippers
•
Utility Knife
•
Insulated Wire Connectors