Cadet RCP402S Owner's Manual

Other manuals for RCP402S: Owner's Manual, Owner's Manual
Manual is about: The Hot One Garage Heater

Summary of RCP402S

  • Page 1

    Owner’s guide the hot one ® features & benefits • commercial grade high temperature manual reset • fan delay eliminates cold draft on startup and disperses residual heat on shutdown • fan only control for cool air circulation • 6 foot cord with polarized 240 volt plug • built-in double pole thermost...

  • Page 2

    2 step 1 heater inspection and assembly step 2 plug and receptacle requirements step 3 assembly placement: the hot one ® may sit on the floor with stand or be mounted to the wall using universal bracket provided. If mounted on the wall, cadet recommends a 12 inch clearance from the top of the unit t...

  • Page 3

    3 1 1 10 9 1 2 3 13 12 5 8 7 6 4 1 3 h h fan switch front auto on terminal block multi-watt switch manual reset limit low high rear fan delay relay important! Always connect heater to properly grounded outlets. Important! This is a 240 volt heater and requires a 240 volt wired receptacle. Do not alt...

  • Page 4

    4 warranty troubleshooting chart consult local electrical codes to determine what work must be performed by qualified electrical service personnel the plug does not fit receptacle heater does not operate elements heat, fan does not operate heater fan operates, but does not discharge warm air heater ...

  • Page 5: The Hot One

    Características y beneficios • reglaje manual de alta temperatura y calidad comercial • la demora (retraso) del ventilador elimina las corrientes de aire frías al arrancar y dispersa el calor residual al apagarse. • control del ventilador solamente para la circulación de aire frío. • cable de 6 pies...

  • Page 6

    2 instalaciÓn: el modelo hot one se puede instalar en el piso con un soporte o bien en la pared con la ménsula universal suministrada. Si se monta en la pared, cadet recomienda un espacio de 12 pulgadas desde la parte superior de la unidad hasta el cielo raso. El modelo hot one no se recomienda para...

  • Page 7

    3 ¡importante! Conectar el calentador siempre en tomas de corriente con la conexión a tierra apropiada. ¡importante! Este es un calentador de 240 voltios y requiere un toma de corriente cableado de 240 voltios. No alterar el cable. ¡importante! El ventilador demorará aproximadamente 20 segundos para...

  • Page 8

    4 solución de problemas consultar con los cÓdigos de electricidad locales para determinar que parte del trabajo debe ser realizada por personal de servicio elÉctrico calificado. El enchufe no calza en el tomacorriente el calentador no funciona los elementos calientan, pero el ventilador no funciona ...