Cadet The Com-Pak Plus Owner's Manual

Other manuals for The Com-Pak Plus: Owner's Manual
Manual is about: Electric Wall Heater

Summary of The Com-Pak Plus

  • Page 1

    Owner’s guide the com-pak ™ plus save these instructions important instructions 11 1 / 2 ” 29.21 3 1 / 4 ” 8.26 1 1 / 4 ” 3.18 10” 25.4 1 3 / 4 ” 4.45 1 1 / 4 ” 3.18 7 7 / 8 ” 20.00 4” 10.16 3” 7.62 9” 22.86 12” 30.48 10” 25.4 11 1 / 8 ” 28.26 12” 30.48 16 1 / 4 ” 41.27 the com-pak tm plus model c t...

  • Page 2

    Installation instructions how do i install for new construction walls? Figure 1 face of wall can must extend 1 / 2 inch or 5 / 8 inch from face of stud to allow for thickness of sheetrock. Step 1 mount the wall can how do i install in an existing wall? Step 1 cut hole in wall route supply wire from ...

  • Page 3

    6” min. 6” min. 6” min. 6” min. Figure 7 figure 6 installation instructions the c series requires a minimum distance of 6 inches from all adjacent surfaces. However, cadet recommends 12 inches from all adjacent surfaces for longer and cleaner performance. Important: do not mount the heater in low-de...

  • Page 4

    The com-pak plus without thermostat the com-pak twin plus without thermostat operation & maintenance how to operate your heater 1. Once installation is complete and power has been restored, turn the thermostat knob fully clockwise. 2. When the room reaches your comfort level, turn the thermostat kno...

  • Page 5

    Warranty consult local electrical codes to determine what work must be performed by qualified electrical service personnel. Symptom problem solution breaker trips immediately upon energizing heater. Heater fan operates, but does not discharge warm air. Heater will not shut off. Heater discharges smo...

  • Page 6: The Com-Pak™ Plus

    Advertencia: desconecte la electricidad en el tablero del panel eléctrico (caja de cortacircuitos o fusibles) y trabe o coloque un cartel en la puerta del tablero del panel para evitar que alguien vuelva a conectar la energía mientras se esté trabajando en el calentador. De lo contrario podrían prod...

  • Page 7: Guía

    Instrucciones para la instalación ¿cómo hago para instalar en una construcción nueva? Figura 1 la superficie de la cámara de pared debe sobresalir de 1 / 2 pulgada a 5 / 8 de pulgada de la superficie del puntal a fin de dejar espacio para la lámina de yeso. La serie c requiere una distancia minima d...

  • Page 10

    ©2007 cadet manufacturing co. Printed in u.S.A. Rev. 11/07 #720080