Caffitaly System S23 Instruction Manual

Manual is about: Capsule Coffee Maker Machine

Summary of S23

  • Page 1

    1 model s23 only use with caffitaly system capsules instruction manual imported by roasting australia holdings pty limited 11 hoyle avenue, castle hill, nsw 2154 phone: au 02 9846 0307 nz 0800 450 894 email: caffitalysystem@rfg.Com.Au caffitalysystem.Com.Au.

  • Page 2: Index

    2 index introduction: • welcome 3 • safety warnings 4 • symbols guide 5 instructions: • machine components/dispensing head 6 • milk jug components/milk jug dial settings 7 • correct use of buttons/indicator lights 8 • first time use 9 • dispensing coffee only 11 • dispensing tea or hot water 12 • di...

  • Page 3: Congratulations

    3 congratulations on the purchase of your new caffitaly system s23 capsule machine. In no time at all you will be producing barista quality coffee including lattes, cappuccinos, hot chocolate with the press of a button, all in the convenience of your home or office. In fact, the choice is endless es...

  • Page 4: Safety Warnings

    4 safety warnings if you do not comply with the operating instructions and safety warnings in this instruction manual, the machine may become dangerous to operate. Please ensure you keep this instruction manual in a safe place. Carefully read the following instructions before use. This way you will ...

  • Page 5: Safety Warnings - Continued

    5 safety warnings - continued symbols guide caution: this is the safety warning symbol. It is used to call your attention to possible risks of personal injury. Abide by the safety messages provided in order to avoid possible injury or death. This is the symbol used to highlight some actions that wil...

  • Page 6: Machine Components

    6 machine components water tank cover milk jug dial milk jug cover button pad lever capsule compartment dispensing head cover dispensing spout detach buttons unlock coffee outlet tube dispensing head dispensing head cover milk jug inlet dispensing spout milk outlet tube reverse side of dispensing he...

  • Page 7: Milk Jug Components

    7 milk jug components milk jug dial settings milk jug dial milk jug milk jug connector milk aspiration tubes figure 1. Minimum amount of frothed milk. Dial is to the left. Figure 2. Medium amount of frothed milk. Dial is to the middle. Figure 3. Maximum amount of frothed milk. Dial is to the right. ...

  • Page 8: Correct Use Of Buttons

    8 correct use of buttons cappuccino button - 180ml (lit in white). Dispenses 30ml of coffee followed by 150ml of hot, frothed milk. Do not use tea capsules. When in doubt follow the directions on the caffitaly branded capsule box regarding required button use. Single espresso button - 30ml (lit in w...

  • Page 9: First Time Use

    9 first time use important information please read these instructions in full before you switch the machine on. Failure to do so could void your warranty. Ensure the milk jug is in position on the machine before switching the machine on using the on/off button for first time use and if the machine h...

  • Page 10: First Time Use - Continued

    10 9. 13. Press the cleaning button to cycle water through the milk system . There will be a slight pause then the milk system rinse cycle will commence & automatically stop upon completion. Open the water tank cover & top up the tank with fresh water to the max. Line indicated. Your machine is now ...

  • Page 11: Dispensing Coffee Only

    11 2. 6. Raise the lever to open the capsule compartment . Insert the capsule, pressing gently into place. Dispensing stops when the programmed amount is reached, or press the button to stop dispensing in advance. When all the button lights remain steadily lit, your machine is ready for use. Warning...

  • Page 12: Dispensing Tea Or Hot Water

    12 dispensing coffee only - continued dispensing tea or hot water tip: to ensure optimum product delivery between uses, eject the used capsule from your machine & rinse by pressing the double espresso button . Raise the lever to eject the used capsule into the used capsule drawer & then lower the le...

  • Page 13: Dispensing Tea Or Hot Water

    13 dispensing tea or hot water dispensing milk based drinks insert the capsule, pressing gently into place. Raise the lever to open the capsule compartment. 6. Plug in your machine & switch it on by pressing the on/ off button. All the button lights will all flash simultaneously for approx. 30 sec. ...

  • Page 14

    14 dispensing milk based drinks - continued always ensure the milk jug is placed back into position gently but firmly onto your machine. There should be no gap between the milk jug connector and the machine. Add fresh cold milk to the milk jug . Note: maximum is 500ml. Replace the milk jug into posi...

  • Page 15

    15 dispensing stops when the selected programmed amount is reached. You can also press the button again to stop the dispensing in advance, e.G. If you like a piccolo or macchiato. When you have finished making your milk beverage, raise the lever to eject the used capsule into the used capsule drawer...

  • Page 16

    16 programming the quantity of beverage in a cup note: the quantity of coffee dispensed may be programmed, from a minimum of 30ml to a maximum of 250ml . Note: recommended programming/factory programming: - 30ml: single espresso shot - 60ml: double espresso shot - 120ml: tea & hot water button note:...

  • Page 17

    17 general operating indications the water tank is empty when the multifunction indicator light blinks red & your machine beeps continuously. When the descaling indicator light blinks orange it is advisable to perform the descaling cycle on page 25. Fill the water tank with fresh water to the max. L...

  • Page 18

    18 general operating indications - continued if the lever is raised: if the lever is raised during the delivery of a beverage, the machine can emit jets of hot water. Risk of burns! The indicator light blinks red and beeps. The appliance will immediately stop dispensing. 1. Close the lever fully. Pr...

  • Page 19

    19 daily maintenance - housekeeping always ensure the water tank is positioned correctly on your machine. Diagram 1. Tilt the water tank slightly and align the groves on the base of the tank and your machine. Slide the tank towards the back of the machine. Diagram 2. Push gently but firmly until the...

  • Page 20: Daily Maintenance

    20 daily maintenance cleaning – rinse cycle 3. 3. Fill the water tank with fresh water & return the water tank, drip tray & used capsule drawer back to their positions on your machine. Repeat cycle if necessary. Remove the water tank . Empty & rinse out the tank. The water tank is not dishwasher saf...

  • Page 21

    21 cleaning - milk system rinse cycle ensure the water tank is topped up with water. Place a large empty container (at least 500ml) under the dispensing spout. Press the cleaning button. The button will continue to blink while cleaning (approx. 50 sec.). The milk system rinse cycle will stop automat...

  • Page 22

    22 cleaning – detaching the components for best results, it is recommended that the milk jug is given a complete clean at the end of each day. Start by running a milk system rinse cycle as described on the previous page. Please perform a full cleaning process at least twice a week. Remove the milk j...

  • Page 23

    23 cleaning – detaching the components - continued continued on next page... >> to remove the milk connector out knob , turn the dispensing head to the back. On the left side you will see the knob in the ‘locked position (image 1). Unlock the knob by rotating it to the right (anticlockwise). When un...

  • Page 24

    24 cleaning – detaching the components - continued when assembling the milk aspiration tubes , ensure the connections are flush with each other. Also check the connection when placed back into milk cover . Always ensure the milk jug is placed back into position gently but firmly onto your machine. T...

  • Page 25: Descaling Instuctions

    25 i. Descaling instuctions carefully read the directions for use on the package of the descaling agent. Avoid contact with eyes, skin and machine surfaces. Do not switch off the appliance during descaling and do not lift the lever. Someone must be present during the operation. Don’t use vinegar: it...

  • Page 26

    26 descaling instuctions - continued add the 1 litre of descaling solution to the water tank. Place at least a 1 litre empty jug under the dispensing spout. 8. Press and hold the cleaning button in for two seconds (2 seconds), then release. This will commence the descaling cycle . The cleaning butto...

  • Page 27

    27 descaling instuctions - continued remove the water tank , empty the remaining descaling solution & rinse the water tank with fresh clean water. Replace back onto your machine. The lights will blink while the machine warms up. Open the water tank cove r and fill the tank with fresh water to the ma...

  • Page 28

    28 descaling instuctions - continued restore factory settings (reset) open the water tank cover & top up with fresh clean water if required. Your machine is now ready to use. These instructions allow you to reset the machine back to its factory setting – helpful if you experience an issue with the m...

  • Page 29: Energy Saving

    29 energy saving after 10 minutes of disuse the machine turns off automatically & the button lights will slowly and sequentially blink. To start using your machine again, press any button or lift the lever. 1. 2. All the button lights will blink as the machine warms up. Approx. 20 to 30 seconds. You...

  • Page 30: Troubleshooting

    30 troubleshooting problem cause solution first use there is a burning smell when the machine first starts and a beverage button is pressed. - machine heating up for the first time. - there may be a slight burning smell coming from the machine when first used. This is caused by the water heating as ...

  • Page 31: Troubleshooting - Continued

    31 troubleshooting - continued problem cause solution dispensing when a coffee dispensing button is pressed, the machine starts running, but stops without dispensing coffee or after dispensing only a small amount. (under 30ml). - pre-infusion - incorrect beverage quantity programming. - pre-infusion...

  • Page 32: Technical Data

    32 technical data all materials and objects in contact with food products comply with the requirements of european regulation 1935/2004. Please dispose of the packaging and capsules thoughtfully. Cardboard and capsules are recyclable.Before recycling your capsules, ensure you contact your local wast...

  • Page 33: Warranty Details

    33 warranty details dear customer, thank you for buying this product. This machine has been designed and produced using the best technologies available. 1. Warranty details: (a) if your caffitaly system machine develops a fault or defect during the warranty period, and subject to the terms below, we...

  • Page 34: Notes:

    34 notes:.

  • Page 35: Notes:

    35 notes:.

  • Page 36: Www.Caffitalysystem.Com.Au

    For more information on the machine operation, available capsules and other useful hints and tips go to the caffitaly website: www.Caffitalysystem.Com.Au only use with caffitaly system capsules the unique caffitaly system capsule what sets us apart from the rest? Our unique filtered capsule design e...