Landcell™ 819 ‐ 1xrt modem 8 8 1 1 9 9 ‐ ‐ 1 1 x x r r t t ‐ ‐ x x x x x x cdma 1xrtt serial cellular data modem quick start guide 004 ‐ 0003 ‐ 819 rev 2 released january 2008 updated february 2008.
819 ‐ 1xrt serial cellular data modem 2 copyright notice © copyright 2008 calamp. All rights reserved. Industrial & monitoring control division, 299 johnson ave., ste 110, waseca, mn 56093 tel 507.833.8819 fax 507.833.6748 email landcell@calamp.Com this quick start covers the operation of the landce...
819 ‐ 1xrt serial cellular data modem 3 general this guide details quick activation of the landcell™ 819 ‐ 1xrt modem. The following modem setup examples apply for windows 98, me, nt, 2000 & xp®. Due to the divergent graphical interfaces of these different operating systems, there may or may not be ...
819 ‐ 1xrt serial cellular data modem 4 do not operate in locations where medical equipment that the device could interfere with may be in use do not operate in fuel depots, chemical plants, or blasting areas unless use has been approved and authorized use care if operating in the vicinity of protec...
819 ‐ 1xrt serial cellular data modem 5 landcell products and accessories product description catalog no. 819 ‐ 1xrt cdma 1xrtt data modem 819 ‐ 1xrt ‐ xxx* antenna 4” antenna 3” mag mount antenna l2 ‐ ant0001 l2 ‐ ant0003 power supply 110 vac input dc power cable l2 ‐ pwr0001 l2 ‐ pwr0002 interface...
819 ‐ 1xrt serial cellular data modem 6 front panel connections rf female sma agps female sma (optional) back panel connections power jack 2.1x5.5mm dc barrel (center positive) rs ‐ 232 serial port, standard de ‐ 9 female setting up the 819 ‐ 1xrt modem using the 819 ‐ 1xrt cdma driver: you may down...
819 ‐ 1xrt serial cellular data modem 7 configuring the modem 1. Click on start → settings → control panel. Select phone and modem options . 2. Click new . 3. In location name , enter a name to distinguish this connection (i.E., 819 ‐ 1xrt). Type your area code in the area code box. 4. Click apply a...
819 ‐ 1xrt serial cellular data modem 8 figure 1: 819 ‐ 1xrt hyperterminal port settings 4. Confirm contact with the modem with at+gsn. This prints out the esn of the modem i.E. (+gsn: 45262036). If you get an error or no communication message, verify the modem is connected to the proper com port an...
819 ‐ 1xrt serial cellular data modem 9 10. You can also confirm the assigned prl number with at+gmr . Power cycle the modem. If your account supports voice, you can confirm modem activation by performing a voice call to your cell phone with at+cdv phone number> (use no spaces or angle brackets). Yo...
819 ‐ 1xrt serial cellular data modem 10 standard rs ‐ 232 de ‐ 9 pinout table 1: de ‐ 9 pin out description (direction is dte relative to dce) pin name direction description 1 cd ← carrier detect 2 rx ← receive data 3 tx → transmit data 4 dtr → data terminal ready 5 gnd system ground 6 dsr ← data s...
819 ‐ 1xrt serial cellular data modem 11 appendix 1: subscriber activation verizon wireless subscribers for verizon wireless subscribers residing in the united states, the standard provisioning procedure is by issuing the command at+cdv*22899 . If the modem will not provision and you have verified t...
819 ‐ 1xrt serial cellular data modem 12 sprint pcs subscribers sprint pcs uses iota (ip ‐ based over the air) for their over ‐ the ‐ air provisioning system. Iota uses packet data calls to transfer the configuration data to the phone. These iota data sessions can be network initiated or client init...
819 ‐ 1xrt serial cellular data modem 13 alltel subscribers alltel uses both otapa and a manual process for provisioning modems. The otapa process for voice phones is not normally possible with a modem, so the manual process must be followed. The esn is entered into their database and an mdn and min...
819 ‐ 1xrt serial cellular data modem 14 telus (canada) subscribers the standard procedure to provision the modem is by issuing the command at+cdv*22803 . If the modem will not provision and you have verified with telus the serial number is activated in their systems, manually key in the phone numbe...
