Cal Boats CAL 27 Mk III Owner's Manual - Commissioning Notes
10
COMMISSIONING NOTES
COMMISSIONING NOTES
Note No.1
If your Cal Yacht is supplied with a 110V AC shore-power system, it will have a control panel
with a main breaker (30 amp) and separate (15 amp) breaker switches for the outlets and
water heater . In addition, there are both audible (buzzer) and visual (yellow light on panel)
reverse-polarity indicators . With all switches off, attach the power cable to the power inlet on
the boat . Next, connect the power cable to the dockside outlet . It is recommended that any
appliances used on board be wired with three-wire grounded plug .
WARNING: IF THE POLARITY INDICATORS LIGHT AND/OR SOUND, DISCONNECT THE
CORD IMMEDIATELY . THIS INDICATES A REVERSE POLARITY SITUATION WHICH IS
DANGEROUS . SEVERE INJURY OR DEATH MAY RESULT . DIAGNOSE AND CORRECT THE
PROBLEM BEFORE PROCEEDING .
Note No.2
If your Cal Yacht is equipped with a water heater, it will be installed to operate off both the
engine cooling system and the 110V AC electric system . Before switching the 110V system on,
be sure the water-heater tank is filled . Open the valve in the inlet water line, and be sure the
check valve is installed with the arrow pointed toward the water heater . Operate the pres-
sure-water system until you get a steady stream through the hot-water faucets .
WARNING: FAILURE TO FILL THE WATER HEATER BEFORE SWITCHING ON THE 110V
CIRCUIT WILL RESULT IN DAMAGE TO THE HEATING ELEMENT .