Caliber MCD 165 Instruction Manual - 8. Rds Operations

Manual is about: CAR CD/MP3 PLAYER / RDS RECEIVER

Summary of MCD 165

  • Page 1

    Instruction manual car cd/mp3 player / rds receiver mcd 165.

  • Page 2

    Band 1 2 3 4 5 6 disp this unit is equipped with the most advanced “touch sense panel” which is easy and convenient to use. And here is some tips on how to use this touch sense panel: tips the pressing or activating of each button actually all you need is a very light touch, even not really necessar...

  • Page 3: 1. Handling Compact Discs

    E - 2 1. Handling compact discs moisture condensation notes on cds p. 2 p. 3 p. 4 p. 1 p. 5 p. 6 p. 7 1. 2. 3. 4. 5. Notes on discs there are paste residue. Ink is sticky (p.5). Stickers that are beginning to peel away, leaving a sticky residue (p.6). Labels are attached (p.7). On a rainy day or in ...

  • Page 4: 2. Installation

    2. Installation before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consu...

  • Page 5

    Din rear-mount (method b) installation using the screw holes on the sides of the unit. Fastening the unit to the factory radio mounting bracket. 1. Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted) and tighten the screws at 2 plac...

  • Page 6

    3. Detachable control panel (d.C.P.) removing the detachable control panel (d.C.P.). 1. Turn the power off 2. Press the d.C.P. Release button 3. Remove the d.C.P. Panel release button b a 2 attaching the dcp caution 1. Attach the panel at the right side first, with point b on the main unit touching ...

  • Page 7: 4. Wiring Diagram

    4. Wiring diagram amp connector iso female with male terminal iso connector 4 pin+8 pin 1 1 2 3 7 5 7 5 3 8 6 4 2 4 6 8 (see figure 1) figure 1 iso connector wiring chart ground power antenna battery(+) ignition(acc) right rear speaker (-) right front speaker (-) left front speaker (+) right front s...

  • Page 8: 5. Basic Operations

    Press this button to remove the control panel. 5. Basic operations 1) panel release button (rel) 11) disp button(disp) 13) power on/off button ( ) press the power button on the front of the unit to turn on the unit. Long press the power button to turn off the unit. 13) mute button (mute) short press...

  • Page 9: 6. Menu Operations

    6. Menu operations time set (clk) the time on the clock is set to “12:00” by default, rotate the encoder volume knob to adjust the minutes and hours.Press audio/menu button to select the hour or minutes. Note: time format can not to set up, it should be follow the tunner area to change, when is in u...

  • Page 10: 7. Radio Operations

    7. Radio operations 9) radio signal strength meter (rslm) this is use to indicate the signal strength of current radio station broadcast. When you choose radio mode, it will show on the display. 7) station preset buttons (m1-m6) 1.Press these buttons briefly to recall the stored stations in the sele...

  • Page 11: 8. Rds Operations

    17)ta button when pressed short, it is activated as ta mode on or off when ta mode is on and traffic announcement is transmittude - when the unit is in cd mode, it will switch to radio mode temporarily. - if the volume lever was under the threshold point, it will be raised to the threshold point. - ...

  • Page 12

    Overview of the rds function radio data system (rds) is a broadcasting service that allows fm stations to send additional digital information along with the regular radio program signal. Your car stereo offers you a variety of services. Here are just a few: - pi (program identification) it is a code...

  • Page 13

    Programmable optionals - ta seek, ta alarm to determine what action will the radio take if the newly tuned station does not receive tp information for 5 seconds. Ta seek the radio retunes to a different station which contains tp information. Ta alarm the radio does not retune but beeps will come out...

  • Page 14: 9.Cd Operations

    9.Cd operations 4) cd slot insert the disc into cd slot. The cd will begin to play. M1) pause button (pau) press this button to pause cd play, press again to release pause. M2) introl button (int) press this button, the first 10 seconds of each track will be played sequentially until this button is ...

  • Page 15: 12.Mp3/wma Operations

    Notes : loading disc navigating through directories and tracks insert the cd as usual, if it is an mp3 cd, the display will show “mp3 t01” then the message “reading” will appear, when disc scanning completed, the first track on the first directory will play. - an mp3 directory is shown in this manua...

  • Page 16

    (2) search directory / track name by using encoder volume knob under mp3 play mode, press mp3 menu button twice, the display shows “ * “. Rotate the encoder volume knob for selecting the character. In this encoder search mode, select button use as move cursor. Press band/loudness button use as mp3 c...

  • Page 17: 11.Specifications

    General am/mw power supply polarity speaker impedance power output frequency range intermediate frequency usable sensitivity stereo separation s/n ratio dc 11 -14v negative ground 4 ohms 7 5w x 4 87.5-108 mhz 10.7 mhz better than 15db at s/n 30 db 25 db at 1khz 50 db 11.Specifications cd player rema...

  • Page 18: 12.Trouble Shooting

    12.Trouble shooting before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom cause solution no power the car ignition is not on. If the power supply is properly connected to the car acces...