Calibre UK DL-P/H Installation Instructions
Warning LED(s)
1. Consult with vehicle owner about LED location. For best visibili-
ty, choose a mounting location as close to the vehicle gauges
as possible.
2. Check for proper clearance behind the area where the LED(s)
will be installed (approximately 1”) and drill a 3/16” hole in the
chosen location for the LED(s). CALIBRE DL/H models require
the mounting of a second LED for rear radar warnings.
3. Route all of the LED wires under the dash per DIAGRAM A1.
FRONT
ALERT
REAR
ALERT
GREY LED WIRE
GREY LED WIRE
The included CALIBRE Remote Control is used to allow the driver to adjust settings on the
CALIBRE and to mute audio alerts during prolonged encounters. It may be mounted virtually
anywhere inside the vehicle with the included double stick tape or remain unmounted.
DIAGRAM A1
&
Warning Pod(s)
1. Consult with vehicle owner about Pod location. For best visibility,
choose a mounting location as close to the vehicle gauges as
possible.
2. Before mounting the Warning Pod(s), clean both the Pod surface
and desired mounting location on the dash with isopropyl alcohol.
3. Position the Warning Pod(s) on the dash with the provided double
stick “O” ring tape. CALIBRE DL-P/H models require the mount-
ing of a second Pod for rear radar warnings.
4. Route the black cable(s) from the Warning Pod(s) through or under
the dash per DIAGRAM B1.
DIAGRAM B1
FRONT
WARNING POD
REAR
WARNING POD
WHITE
GREY
BLUE
GREY
&
1. Remove the under dash
panel and mount the Interior
Network Module using the
supplied cable ties to the
existing factory wire looms,
brackets, or other support
structures as per DIAGRAM
C1. The Interior Network
Module can be mounted
horizontally or vertically
under the dash.
2. Connect the LED, ignition-
on, and ground wires per the
separate enclosed block
diagram sheet.
HORIZONTAL MOUNT
VERTICAL MOUNT
INTERIOR NETWORK
MODULE
WIRE TIE
WIRE TIES
WIRE TIE
DIAGRAM C1
INTERIOR NETWORK
MODULE
Interior Network Module
WHITE LED
WIRE
BLUE LED
WIRE
“O” RING
TAPE
“O” RING
TAPE
DL/SL HARDWIRE SERIES
DL/SL HARDWIRE SERIES
Installation Instructions
& Recommended Procedures