Calibre UK JPS-3300M Instruction Manual - page 6
5
8
E
C
5
BLACK
RED
10
ATTENTION!
1. The activity of engine cranking will last for 4 seconds and the Jump Start function will automatically cut off .
If the vehicle has not started in this time, wait for 15 seconds and repeat again. (Maximum 5 cranking
attempts are recommended, otherwise the device might be damaged.)
2. Once
possible.
the car engine has successfully started, press the power button to turn off the device as soon as
3. Always recharge the device after use.
4. In case of reversed polarity or if you try to crank an engine exceeding its capability, the device will enter
automatic protection mode and all functions will be terminated. The red LED on the Jump Start will flash.
Please turn off the device immediately and try the next attempt until the conditions are clear.
OPERATION OF CAR WITH A WEAK BATTERY (EXTREMELY LOW VOLT.)
Indication: Jump Start red light is flashing
Power on the Mini Jump Starter. To energise the output manually, hold the Jump Start and Weak Battery Jump
Start simultaneously for 3 seconds. The Jump Start light is flashing and the clamps will be live in this condition.
Please ensure correct polarity is connected before these 2 buttons are pressed, otherwise the device will be
severely damaged. Turn the vehicle’s ignition over until the engine starts, the device will turn off after cranking for 4
seconds. If the vehicle has not started within this time, wait for 15 seconds and repeat again. (Maximum 5
cranking attempts are recommended, otherwise the device might be damaged.)
ATTENTION:
1. Once the car engine has successfully started, press the power button to turn off the device as soon as possible.
2. The device will automatically shut down after idling for 2 minutes.
3. Always recharge the device after use.
4. While the device has inbuilt spark and surge protection, it is best to avoid trying to crank an engine
.
exceeding its capability.
circuiting or dead.
Please replace the battery as soon as possible or get in contact with a professional to examine the car.
5. In cases where the operation has failed and Jump Start red light is flashing, the car battery is either short
CONDITIONS OF USE
Ensure the below conditions are met before pressing the JUMP START button.
1.
Ensure the capacity of the battery is full
Jump Start can only be used when the
spectrum lights up to GREEN or YELLOW.
Jump Start can’t be used when the spectrum
of ORANGE, RED light is illuminated or RED
light is flashing, fully charge the device
immediately.
2.
Ensure the polarity is properly connected
Indication:
In cases of reversed polarity, the battery
indicator will be will be flashing
simultaneously once the power is turned on.
3.
Ensure the contact terminals of the car battery are clean.
Remove any corroded substance from battery terminals and
ensure correct contact point at the clip. Please note that the
battery terminals must be properly connected before pressing
the JUMP START button.
4.
Ensure the cable is properly wired and well connected.
Detach by removing the plug only. DO NOT pull the cable to
detach it from the device.
DO NOT bend the cable when carrying the device.
ORANGE
RED
GREEN
YELLOW
ORANGE
RED
GREEN
YELLOW
ORANGE
RED
GREEN
YELLOW
ORANGE
RED
GREEN
YELLOW
ORANGE
RED
GREEN
YELLOW
ORANGE
RED
GREEN
YELLOW
ORANGE
GREEN
YELLOW
RED