Calibre UK PCI90 I2C User Manual - Calibre
CALIBRE
Issue 1.1
Page 5
06/03/2007
INSTALLING THE ADAPTER UNDER WINDOWS NT4
3.1.
Introduction
This section details the installation of the PCI90 I
2
C communications adapter under Windows NT4.
3.2.
Installing the Adapter
Turn off your computer and disconnect it from the mains power supply. Remove the PC cover and then
a PCI slot blanking plate.
Insert the card into the PCI slot, ensure that it is fully home and screw the adapter panel into the PC.
Replace the PC cover and reconnect the PC to the mains power supply. Turn the PC on.
3.3.
Installing the Device Driver
TO INSTALL A DRIVER YOU MUST HAVE ADMINISTRATOR PRIVILAGES.
Copy all the following files from the CD (located in the \cd_pci directory, to c:\winnt\system32\drivers
1)
CaDrv.sys
-
The device driver
2)
CaDrv.ini
-
The device driver initialisation file
3)
Regini.exe
-
This a Microsoft registration program
From a DOS window, change the directory to the \system32\drivers (usually c:\winnt\system32\drivers).
Then type
regini cadrv.ini
NOW SHUTDOWN YOUR PC
3.4.
WinNT4 File Location
If you are going to use the dynamic link library to write your I2C protocol software click on the
PCI_UTILS follow the instructions to unzip the files (if you do not have an unlock code please contact
sales@calibreuk.com
). Then
1)Copy the Cali2c32.Lib from the \lib directory into your compilers \lib
2)Copy the cali2c32.Dll from the \lib directory into \WINNT\SYSTEM