Califone DVD-110 Owner's Manual - Getting Started
9
Vi s i t u s o n l i n e a t c a l i fo n e. co m
Getting Started
Audio Connection
There are two kinds of audio output: analog audio output and digital output. The analog audio output has two tracks of stereo
sound after DTS decoding, Dolby AC-3 and 2.1 sound track video. Digital video has optic fiber output and coaxial output. The
best audio is found by usually using digital audio output, followed by analog audio output.
Stereo output
Connect a pair of RCA cables (red on the right, white on the left) to the audio out of the player, and to the stereo
audio in of TV or stereo power amplifier.
Coaxial output
Connect special coaxial digital audio out jack of the player, and to coaxial audio out jack of the power amplifier
(with coaxial digital input).
Optic fiber output
Connect special optic fiber cable to optic fiber digital audio out of the player, and to the power amplifier
(with optic fiber cable digital input).
Notice:
• The selection of the connection of audio frequency depends on other neighboring appliance configurations.
With a TV you can only choose stereo output.
• Power amplifier with either coaxial or optic fiber inputs allow you to enjoy the hi-fi effects of DTS and MPEG-II formats.
• Each connection should be in accordance with the configuration of the player. Refer to the karaoke and system setting
instructions in this manual.
• Consult the instruction manual of the unit you want to connect the DVD110 to. Make sure to first turn the
power off of both units.
• The output of DVDs have a wide dynamic range, so the volume of the power amplifier should be moderate,
otherwise the loudspeaker may be damaged by sudden loud noises.
• When using the player, turn off the power amplifier before switching the power on or off of the player,
otherwise the loudspeakers can be damaged.