California air tools pro 1005 composite orbital sander model no.: pro 1005.
Technical data sanding pad………………………………………………………………………..5” (125 mm)/6"(150 mm) free speed…………………………………………………………………………10,000 rpm air consumption…...……………………………………………………………….2.8 cfm (79.2 l/min) operating pressure ………………………………………………………………..90 psi (6.3 bar) air inlet size …………………………………………………………………………1/4...
Air supply 1. Ensure tool air valve (or trigger) is in the “off” position before connecting to the air supply. 2. You will require 90 psi of air pressure 2.8 cfm of air flow. 3. Warning! Ensure the air supply is clean and does not exceed 8bar (120psi) while operating the sander. Too high air pressur...
1. As a standard practice, drain water from the air compressor tank and air lines prior to use each day (reference your compressor operators manual for detailed instructions). 2. Install a 1/4” male connector (not included) into the air inlet port on the tool. 3. Turn on the air compressor and allow...
Problems possible causes remedies tool runs at normal speed but loses under load ■. Motor parts worn. ■ cam clutch worn or sticking due to lack of lubricant. ■ lubricating clutch housing. ■ check for excess clutch oil. Clutch cases need only be half full. Overfilling can cause drag on high speed clu...
Exploding view spare part list no. Description no description no. Description no. Description 1 rubber grip 14 cylinder front plate 27 bolt m4×10 40 regulator 2 housing 15 gasket 28 jacket 41 pin 2×19 3 bolt m5×0.8×4.3 16 bearing washer 29 sanding pad 42 bolt 4 washer 17 washer 30 trigger 43 o-ring ...
Limited warranty this warranty is limited to california air tools and sprayit products. Limited warranty: 1 year california air tools, inc. Will repair or replace, free of charge, to the original retail customer whom purchased a california air tools or sprayit product from an authorized dealer, dist...
