California Trimmer RC190-GCV160 Operator's Manual - page 7
AIR CUSHION HOVER MOWER OPERATOR’S MANUAL
Evergreen Turf Equipment, LLC • 1028 4
th
St. SW, Bldg. A • Auburn, Washington 98001 • caltrimmer.com
Mower Operation (continued)
Release the engine stop lever and allow the engine
to cool before making inspections or adjustments,
and when transporting.
3. Cutting Height Adjustment
The unit’s cutting height is adjusted by moving the
spacers on either side of the tri-blade assembly (the
triangular shaped component that holds the flail blades).
Loosen and remove the center bolt to disassemble the
components. Placing all 3 of the spacers ABOVE the tri-
blade assembly will provide the lowest cutting height,
while placing 2 spacers below will provide the highest
cutting height.
IMPORTANT!
Always install the tri-blade assembly with the flail
blade mounting nuts facing upward (toward the
impeller / engine side).
At least ONE spacer must remain above the tri-
blade assembly at all times against the flange as
shown in the illustration.
The mounting components; hub, spacers, tri-
blade assembly and flange, must be installed,
aligned and seated properly before tightening
the bolt.
4. Transporting
An optional wheel kit (order # 4041500) is available for
quick and easy transporting.
Mower Maintenance
The following maintenance topics are general practices
that owners can do to keep the mower in good working
condition. For any service or repair issues beyond these,
it is recommended that the unit be inspected by an
Authorized California Trimmer Dealer.
IMPORTANT: Avoid damage! Operating in extreme
conditions may require more frequent service
intervals. Engine components may become dirty or
plugged when operating in extreme heat, dust or
other severe conditions.
DAILY INSPECTION (COMMERCIAL USE)
EVERY 8 HOURS (NON-COMMERCIAL USE)
1. Check engine oil level and air cleaner per the engine
manufacturer’s instructions.
2. Inspect the cutting blades for damage and
movement – NOTE: the blades are reversible and
use only genuine California Trimmer replacement
parts.
3. Do not operate the unit without all (3) blades
properly installed.
4. Remove debris and grass from the engine mounting
base area and the engine air intake – which is part
of the recoil starter.
5. Check the impeller and mower deck for cracks or
damage.
6. Check the tightness of the handle mounts.
7. Clean excess grass buildup from the underside of
the deck.
8. Replacement parts are available from Authorized
California Trimmer Dealers. The parts manual is
available for download at:
http://caltrimmer.com