CALOR 6341 User Instructions - Eng
ENG
b) Models 6341 (750/1500 W) and 6343 (1000/2000 W) (fig. 5).
You can choose the most appropriate power according to the re q u i red speed of the tempera-
t u re increase in the ro o m .
To obtain 750 W (Mod. 6341) or 1000 W (Mod. 6343), turn dial B to position
●
.
To obtain 1500 W (Mod. 6341) or 2000 W (Mod. 6343), for rapid heating of the room, turn dial B
to position
● ●
.
- In both cases, the room temperature must be regulated according to the position of the ther-
mostat dial A.
- Your appliance will operate until you turn dial B back to position 0 : off .
c) Model 6344 (fig. 6).
Tu rn dial B to position
●
.
- The appliance can then generate a maximum power of 2000 W, regulated according to the
position of the thermostat dial A.
- Your appliance will operate until you turn dial B back to position 0 : off .
- If you turn dial B to position , the appliance will operate for 2 hours and will still be re g u l a t e d
by the therm o s t a t .
- After 2 hours, the appliance cuts out. To turn it on again, turn the dial to position
●
then back
to position if you wish to re s t a rt a 2 hours cycle.
d) Model 6345 (fig. 7).
Your appliance can be turned on manually or by pro g r a m m i n g . In both cases, your appliance will
generate a power of 2000 W, regulated according to the position of the thermostat dial A.
■
Tu rning on the appliance manually.
Tu rn dial B to position
●
.
Your appliance will operate until you turn dial B back to position 0.
■
P rogramming the appliance.
Tu rn dial B to position (fig. 7).
With the pro g r a m m e r, you can programme the operating and stop times in intervals of at least
30 min. over a 24 hour period.
- You must first set the time on the appliance’s clock, by turning the programming dial to the right,
in order to position the figure re p resenting the time against the mark on the housing (fig. 9).
- Then pull the studs outward s to define the re q u i red operating periods.
For example : if you wish to programme your appliance to heat your bathroom from 6 a.m. to
8 a.m., pull out the 4 studs located between graduations 6 and 8 (fig. 9).
A c c o rd i n g l y, your appliance will start up every day from 6 a.m. to 8 a.m. and will be re g u l a t e d
a c c o rding to the thermostat position.
Nota : you can stop your appliance m a n u a l l y during programmed operation by positioning dial
B on 0 or operate it outside the programmed operating times by positioning dial B on manual
operation position
●
, without modifying your daily pro g r a m m i n g .