CALOR Dehumidifier Instruction Manual - Electrical Requirements
Electrical requirements
Connector
(located inside of the hole)
Knob-Cover
Fig.a
Fig.b
Hose
water tank
Water will drain into the tank.When the tank is full and the
unit stops operating,the WATER FULL indication light will
flash.The water tank can be emptied in one of the following
two ways:
1.Empty the tank manually:
*
Remove the tank as shown.Be careful while taking out the
tank as it can be heavy,it is advisable to carry the bucket
by supporting it from bottom.
*
Empty the water and replace the tank properly,make sure
the slots on the back of the tank are positioned correctly.
WATER DRAINAGE METHODS
CAUTION
!
*
Do not remove the water tank whilst the unit is still working or just stopping.This might cause
some water to drip on the unit.
2.Continuous drainage:
*
On the rear of the unit,locate the plastic"Knob-Cover",rotate it 90 degrees counter-clockwisely
and then pull it out(see fig.a)
*
Push a garden hose (internal diameter 11.5mm)onto the connector located inside of the hole.
*
The hose should go down smoothly without bends or kinks(see fig.b).
*
Place the end of the hose into a suitable drainage facility.
INSTALLATION
The appliance shall be installed in accordance with national wiring regulation.This appliance is fitted
with a plug and rated fuse.If the supply cord is damaged,it must be replaced by the manufacturer or
its service agent or a similary qualified person in order to avoid a hazard.
4
!
WARNING
Do not connect the power source cord in the middle;using extension cords and sharing one
socket with other electric appliances are prohibited.