Calumet 7100 Series CK7114 Operating Instructions - page 2
OPERATING INSTRUCTIONS
www.calumetphoto.com
A
B
C
E
F
Leg Angle
Adjustment
Each leg can be set to
three different leg
angles of spread. Pull
each leg away from the
center column and it
will automatically lock
into the first position. To
change the angle of a leg, pull out the leg-angle lock (E)
and begin to pull out the leg. To set the leg at the second
position, push in on the leg-angle lock before you pass the
second-angle notch and pull the leg into the second
position. To set the leg at the third position, repeat this
procedure by placing the leg-angle lock against the third-
angle notch. To return the leg to the original position,
simply push leg back in towards center column until the
leg-angle lock clears the first-angle notch and slide the
lock back into lock position.
Leg Extension and Setup
One leg at a time, unlock the
top quick-release leg lock (A)
and pull out the top
telescoping section all the way
and relock quick-release.
Repeat until top section of all
three legs are fully extended. If
additional height adjustment is required, unlock the
middle and bottom quick-release leg locks (B and C) of
each leg individually and extend to desired height.
Next, using both hands, pull two of the legs away from
the center column (D) and touch tip of third leg to ground
and pull the two legs towards you until leg angle is equal
on all three legs.
D
G
H
I
L
J
K