Cam Spray 1700SHDR Operator's Manual - page 7
Cause
-Leak in trigger or discharge
-High humidity or direct water spray
-Worn seals
-Burner switch in ‘off’ position
-Burner switch on but pump switch off
-Inadequate fuel supply
-Plugged fuel filter
-Trigger gun not pulled on
-Thermostat turned off
Malfunction
U
Unnllooaaddeerr ccyycclleess w
whheenn gguunn iiss
sshhuutt ooffff
W
Waatteerr iinn ccrraannkkccaassee
W
Wiillll nnoott pprroodduuccee hhoott w
waatteerr
Remedy
-Inspect leaking fittings and repair or replace
-Reduce oil change intervals
-Replace seals
-Turn burner switch on
-Turn on pump switch (must be on for heater to
operate properly)
-Fill tank with kerosene, no. 1 or no. 2 diesel
-Replace fuel filter
-Pull trigger gun (water flow must go through
coil to operate heater
-Turn thermostat dial to the ‘on’ position
Troubleshooting: common problems and solutions, cont.
For problems beyond those listed, refer to flow chart included with the burner breakdown.
7