CAMBOARD AKM MAAP Installation Manual - page 3
3
Extender AKM MAAP • Installation Guide
7.
Connect video, audio, and power cables to each device (MAAPs, input/
output devices, and Extender) as explained in the documentation that
accompanied each device.
8.
Attach the MAAPs to the faceplate.
a.
Place the MAAP module or faceplate on/through
the top of the main enclosure.
b.
Use the included socket head cap screws and
Allen wrench to secure the MAAP to the
faceplate. See the figure at right.
c.
Repeat steps 8a and 8b until all MAAPs have
been installed.
9.
Power up the output devices, the Extender, and the input devices, and test the
system. All devices should have power, and the audio and video should be
working properly. If not, check all cabling and switch settings, and make
adjustments as necessary. See “Pre-installation testing/troubleshooting” in
the Extender Series User’s Manual for details.
10.
When testing and adjustments are completed, remove power from all input
devices, output devices, and the Extender; and disconnect input cables from
the Extender and MAAPs.
11.
Lower the main enclosure onto the upper mounting plate and slide it
backwards so the tab on the upper mounting plate is inserted into the slot in
the lower rear of the enclosure. See the diagram below.
CAUTION
Take care not to damage the cables during this procedure, and make sure
no cables are caught between the enclosure and the mounting plate.
EX
TE
ND
ER
A
KM
M
AA
P
CO
MP
UT
ER
IN
AU
DIO
IN
12.
Align the two holes in the enclosure’s front flange with the corresponding
holes in the upper mounting plate, and fasten the enclosure securely to the
plate using the two remaining Phillips pan head screws.
EX
TE
ND
ER
A
KM
M
AA
P
CO
MP
UT
ER
IN
AU
DIO
IN
#4 - 40
Socket Head
Cap Screws
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de