CAMBOARD Matrix 3200 User Manual
User’s Guide
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
© 2004 Extron Electronics. All rights reserved.
Installation, cont’d
Redundant Matrix Switcher Power Supply
Matrix 3200/6400 Power Supply
68-355-08
Rev. A
Printed in the USA
06 04
AC power output
cable
AC power input
cable
Figure 3 — Power supply connections
7
.
Connect the AC input cable to the power supply (figure 2).
8
.
Install the spring bracket into the tall
stand-off identified in step 4.
9
.
Press the power supply’s notched edge
into the spring bracket at the selected
installation location.
10
.
Using the tall stand-off as a pivot
point, swivel the power supply into
position until the captive screw
connector engages the short stand-off.
11
.
Hand tighten the captive screw connector.
12
.
Connect the DC output cable (the cable connected in step 5)
to either unused power connector on the main board (the
board on the floor of the switcher).
Use an already-installed power supply as an example to
orient the connector correctly.
13
.
Route cable out of the way and secure it with tie wraps.
14
.
Reinstall any cables and reinstall the front panel door.
Reconnect power to the matrix switcher.
Part Numbers
5 V power supply kit for 7U BME
70-083-01
5 V power supply kit for 5U BME
70-083-02
12 V power supply kit for audio BME
70-084-01
Spring
Bracket
Mounting
Screw
Tall
Stand-off
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de