Yoyo (s) set-up guide.
Pairing process to switch the unit on, simply hold the power button for approximately two seconds, at which point the unit will emit a 4 note tone and the power and battery indicator lights will illuminate. Once the speaker has been powered on, it will display a rapidly blinking bluetooth light ( ) ...
Using the yoyo.
Volume control there are two ways to adjust the volume of the yoyo. The first follows the traditional method of pressing the + or – buttons on the right of the unit (next to the power button). The second can be achieved by adjusting the volume within your connected device. As the yoyo will synchroni...
Gesture control if you leave your hand over the unit and wait until the lights illuminate, this is a good starting point for gesture control. Once the lights are illuminated, please find the control steps below: play - swipe left to right without music playing pause - swipe right to left with music ...
Answering a call once the yoyo has paired with a smartphone, you are able to receive calls from the unit. Once the music stops and you hear your ringtone from the yoyo, briefly press the telephone icon on the top of the unit. After a call has been answered, you are able to use the yoyo as both a spe...
Auto-power down the yoyo (s) has an auto power down (apd) feature. As such, the device will power down after 30 minutes of inactivity. However sometimes, when the audio source level is low (e.G. Phone, tablet etc.), the device can register the signal as lower than the apd threshold. To avoid this pl...
Charging a device the usb port on the bottom of the yoyo (s) speaker has been designed to charge an external device such as a phone or tablet. You are only able to charge the battery of the yoyo (s) speaker via the supplied power supply unit. It is not possible to charge the (s) speaker via the usb ...
