Installation and operation instructions electric fireplace cam30wmef.
Maintenance troubleshooting important safety instructions listing approvals product dimensions locating fireplace unpacking and testing fireplace replacing the rock/log set and light bulbs grounding instructions installation finishing ckecklist operating instructions 4-6 7 8 9 10 10 11-12 13 13-14 1...
1. Prior to plugging your heater into an electrical outlet, verify that the house circuit breakers for the outlet are on. 2. The heater may emit a slight, harmless odor when first used. This odor is normal and it is caused by the initial heating of internal heater elements and will not occur again. ...
Important safety instructions import ant instructions 'mlen using this electric fireplace, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read all instructions before using this electric fireplace. 2. This hea...
Important safety instructions 11 . Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater. 12. To prevent possible fire, do not block air intakes in any manner. Do not use on soft surfaces, like a bed, where...
110-120v ac, 60hz max 1400w 30.6 19.2 5.7 x30wmef.
2 6 5.7.
3.
The manual controls are located on the left side of the fireplace. : s l o rt n o c g n i w o ll o f e h t e v a h u o y 1. Power on/off: power to the unit 2. Flame brightness controls: allows you to adjust the flame to suit your mood.Press to increase flame brightness and to decrease flame brightne...
Replacing the rock/log set and light bulbs to change log/rock set (note: make sure fireplace is turned off and has been unplugged from electrical outlet before attempting to change the log/rock set): 1. Place fireplace on a flat, level surface (fig 1). 2. Remove 3 screws located on each side of glass ...
The remote takes 2 x aaa batteries.
