CAMBRIDGE Qt 100 Installation And Operation Manual - System Configuration Via The
C A M B R I D G E S O U N D M A N A G E M E N T
10
System Configuration via the
Front Panel
After the Qt 100 is mounted and the emitters have been tested, it is
time to configure the Qt 100 for general operation.
The front panel display shows system information and allows for
adjustment of the masking and the auxiliary audio input levels.
System Information
Initial display of the front panel, shown below, shows the software
version and system status.
The VERSION X.X.X indicates the following fields:
major release. minor changes . bug fixes
The BRx format is to identify the version of the internal code and
used as reference for technical support on rare occasions. Status
indicates if there are errors (see Error Format) or if the system is OK.
If the Bluetooth dongle used for configuration by the Qt 100
Configuration Application is installed, the following screen is
displayed. If the dongle is not installed, the screen will not be seen.
"FW1" indicates the firmware version programmed on the dongle and
may change in future editions. "BT Idle" indicates that the connection
is idle. This will change to “Conn” when the configuration app makes
a connection to the controller.
The Cambridge Sound Management support phone number is on the
display as the default service contact.
VERSION X.X.X
Status: OK
BRx
Bluetooth FW1
USB OK: BT Idle
For Service Call
617-349-3779